My asko dishwasher D5424 door latch has jambed so that the door will not open.

Question edited for clarity, add maker.
Question moved from Car and Trucks.

Here is the service manual.

https://www.frontloadbearings.com/asko-dishwasher-3-000-5-000-series-service-training-manual/

How do I replace the the door latch on an asko dishwasher

JustAnswer https://www.justanswer.com > Appliance Repair
Dec 23, 2009 - Just open the door, remove all the screws around the door panel and control panel going around the inner door liner. Remove the 2 screws going ...
1 answer · Top answer: very easy. Just open the door, remove all the screws around the door panel an

Generic video for Smeg

Hello Margaret Watson,

"Dashes" are not on the trouble list...
See below

My best advice: Call ASKO

Customer Care Center
1-800-898-1879
www.askousa.com

Asko D5424 Operating Instructions Manual Troubleshooting

Carnac the Magnificent

Replace the electronic door latch

sounds like the water inlet valve is not working. it is not real hard to replace.

The thing that immediately comes to mind is a faulty door switch or latch. The door switch can be replaced and you might be ok. But the latch would be more tricky to check. Sometimes if dishwasher is not level or if the door springs are misalinged the door tends to slip and release the latch due to pressure. It works when you open and shut. But not sure about the night time cycle. That sounds a bit creepy if it starts again by itself. Why not put a tape around the door and then start. That will help eliminate the obvious ones. The other thing that exends dishwasher cycle time is the lack of adequate water temperature. Could be heater or thermostat or both.
You should be able to stroll through the parts by selecting categories on this site.
http://www.repairclinic.com/Shop-For-Parts/a9b126d867701/Model-D3251White-Asko-Dishwasher-Parts

Hi

Thanks for using FixYa. Sorry, but I don't have good news for you, unfortunately it is time to replace the door latch, hope you understand there is nothing else that you can do with the latch as every other part is working fine. Please accept the solution if the issue is resolved or post a comment for further assistance.

Thanks

Rylee

when you latch the door it closes the circuit.
you may have to open the casing of the door to access the switch. it may be stuck or defective.

If there's a fault it's with your door latch/switch cheers

The only way is to pull out the dishwasher ,unhook the latch and then unscrew the door panel.your dishwasher is installed with 2 screws to the underside of your countertop. its tricky but youll have to remove them adjust to leveling legs down this will give you more room to get some head bit in ther to remove the screws if its out then slide the d/w foward ,remove the strike plate door will open then you can get your dishes out first

the door latch is faulty or needs to be rolled open