How do I take off the top of a fagor undercounter dw

https://www.manualsearcher.com/fagor/f-2810/manual https://www.repairclinic.com/Video/Video-Landing/2920-11/Top-Load-Washer-Won-t-Start-Washing-Machine-Troubleshooting

Fagor Refrigerator manuals


Which Fagor model is it?

The link above is for free manuals for many Fagor models.

plug the leak

I think your problem is with a bad contact switch. Most likely at the door. When door is closed this switch makes contact to engage machine to start. Your machine is electronic, some machines would need a lever to be moved to enable machine to be started. It all comes down to the same thing, power must flow to start the washing. You will need to look for this contact somewhere around the door. GOOD LUCK FRIEND.

This video should help. FAGOR PRESSURE COOKERS Replacing the Upper Handle

I cleaned the smoke filter, took of the top cover, in front of electronics is the brown smoke sensor. I took of one wire off the sensor, started the oven (beware of not shortcutting anything) the f06 error message had disappeared. I put back the wire, mounted the top cover and the oven functions like new.

Hi, I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works like new... However I have also foundthat if the heating element goes bad then that also can mess things up bad...So I would buy new spray arms, and also check out the heating element to makesure it is working... Here is a tip that will help you with the onlinebuying...
Dishwasher SprayArms not Spinning

How to Buy ApplianceParts Online

A bad heating element causes many problems in dishwashers...

Dishwasher Problems The HeatingElement not Working

DishwasherMaintenance DishwasherResidue and Film on Dishes

heatman101

Asker's Testimonial "explanation very clear. will give it a go and see howsimple it was. thanks Ronnie " - ronnieshomes
;l';l;l

If water is flowing, then you should see water enter the DW. You should also feel the water line becoming warm or hot, depending on if metal (copper), insulated metal (copper), or plastic.
If the water valve is partially restricted due to accumulation solids in the water line, then you will need to remove and clean the valve of solids.

Guy from Fagor said brown & blue go to black & red. White and ground together go to green & yellow. Hope he's right.

ok if you have a volt meter then remove the bottom kick-plate locate the water valve take the connector off the valve set the meter to ac volts plug the leads into the connector turn the timer to fill if your getting the proper volts to the connector then replace the valve if nor reply to me