My orbit just says off and when I turn the dial it doesn’t do anything

replace the ac adapter, you should have 24 VAC out of it, check the 24 VAC when each station is running.

Contact the manufacturer. They usually will have the manual online for downloading.

Orbit has video explanation of their sprinkler timer:
http://www.orbitonline.com/tutorials/6station.cfm

Question is not clear.
Do you have programming problem with the timer?
Or problem locating sprinkler heads?
Or a sprinkler valve problem?
Add a comment with detailed information.

Sprinkler timer turns ON-and-OFF.
Timer does not advance the sprinkler to next station. The sprinkler valve advances to next station when timer turns OFF.
For example, when timer turns ON, then station 1 starts watering.
Timer turns off, and then sprinkler valve automatically advances to station 2.
Timer turns on again, and station 2 starts watering.

Orbit resources:
http://www.orbitonline.com/support/
http://www.orbitonline.com/lib/media/InstallationGuide.pdf
http://www.irrigationdirect.com/media/manuals/owners-manuals/orbit/Orbit-WaterMaster-57880-Controller-Owners-Manual.pdf

Had this NOAC problem as well - and with two Orbit controllers not one. Both were new. Turned out to be a fault with the units. Had them replaced.

Hi,

Here you can download anything you need...

Orbit manuals


heatman101

I have done this in a couple ways. With a digital timer you can select a zone on manual and turn only that zone on. with a mechanical timer, you can set the dial to that zone and increas the duration. You can "hot wire" the zone by moving the zone wire to connect to the low voltage wire input to the zone. You can take a transformer out to the ground box and with an extention cord "hot wire " the zone at the ground box.

you need to hard reset your PDA and need to reinstall the OS..this will help you

all the best

Your phone is barred. This means it has been blocked of making or receiving any calls.