Question about Power Acoustik Car Audio & Video
It depends on how many channels are on the Amp. If it's a 2 channel you can bridge it using the positive on one channel and use the negative on the other channel. The Amp will give the sub more power bridging the sub.
Posted on Mar 10, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
This one Wire should be for the +. Try connecting the + to the Head Unit and - to a Common Ground. At the Worst, You will Blow the Amp Fuse if not Correct. The Lead from the Head Unit is Only an Off and On from the Ignition. Please Rate My Response! Thanks!
Posted on Jan 31, 2009
Those MOFO-15's have dual 1ω voice coils. So the only way you can get 2 of them to present a 2ω load is to use 1 voice coil on each one with the two of them wired in series. Using both voice coils, you can get a 1/4ω load by wiring the voice coils in parallel and then wiring the subs themselves in parallel. You'll get a 1ω load with the voice coils in series and then parallel the subs. Or you'll get a 4ω load with both the voice coils and the subs in series.
Here's a link to Power Acoustik's PDF for the MOFO's. I recommend that you check out the wiring diagrams on page 3.
Hope this helps.
Posted on Apr 07, 2009
Make sure the subwoofer is set to low frequency, make sure subwoofer and bass are enabled on the headdeck. Make sure the gain is turned up on the amp, make sure the rcas haven't come out of the back of the head deck.
Posted on Aug 05, 2009
from your sub connect one short piece of cable from + on one side to - on the other side using the same diameter cable as you are running to the sub from amp . this will leave you with + and - on opposite sides of speaker these will then run to the amp +to+ and - to- on the mono side of connetor which is one left + and one - right and the amp switched to bridged
Posted on Sep 03, 2009
Tips for a great answer:
Apr 04, 2014 | Power Acoustik FUBAR-12W Car Subwoofer
Mar 09, 2010 | Power Acoustik Power-Acoustik FUBAR-12W...
May 21, 2009 | Power Acoustik BAMF2000/1D Car Amp
Feb 13, 2009 | Power Acoustik PTID-8960 Car Video Player
Jan 31, 2009 | Power Acoustik PTID-8960 Car Video Player
Apr 05, 2008 | Car Audio & Video
Mar 15, 2008 | Power Acoustik Power-Acoustik FUBAR-12W...
67 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: