Hello i Gave fout code Ricoh mpc 2051 code is 452

http://www.copytechnet.com/forums/ricoh-savin-gestetner-lanier/71447-mpc-3502-sc554-00-holy-sh.html

http://www.copytechnet.com/forums/ricoh-savin-gestetner-lanier/117427-mpc-3502-sc-552-02-a.html

Fusing/Paper exit motor error

Ricoh Aficio MPC2030 Error Codes List page 7 from 15

The error code you gave shows several possibilities for your issue:

Drum charge corona wire, The output of the charge corona wire of the black PCU is abnormal.

Causes

• CGB power pack connection loose, broken defective • Check CGB power pack connection to BCU • CGB power pack defective • BCU defective • Replace OPC drum

Of the five possibilities above, replacing the drum is the most likely cause. Since you only had your drum for a couple of weeks I would take it back to where you purchased it and ask for replacement. Sometimes you get a bad drum out of the box from the manufacturer. It happens. If the same error code pops up again, I recommend you call your local Ricoh dealer for further troubleshooting.

If you wish to get some details about printer repair and service; check the site linked here. Pull up older posts.
http://electro-medical.blogspot.com/

hello when i replace two new hard drive in the machine sais can,t not format the hard drive can somebody help me to fix the problem

I think the sensor you're talking about is the thermopile. If that is what you mean, should give another different code.
Have you sow the fusing exit sensor fan motor (at the front right side of the machine)?

If the model ia a MPC 2800 it a controller board issue maybe the operation panel. -carl

sc 670 on ricoh MP 1600

Hello wajidsn

SC548 : "Fusing Installation Error.Fusing Unit Set Error"