Parrot 7200 battery low audio caution on power up

power supply problem or any power issue must be the problem.
(battery).

if all are ok cct board problem.
regards.
nuwan

Hello. When you pairing a blue tooth with a samsung if required a code it would be 0000 unless is a specific code by the manufacturer.
Fix: turn off the blue tooth on settings on the phone and turn it on. Let the phone scan for devices, if it says found p that should it. When you see it on the phone press on it, the phone and Bluetooth should pair by doing so. I hope this helps. Good luck.

1. Turn the power switch to "O" (OFF) position.
2. Open the ADF door.
3. Remove the battery together with the battery holder.
CAUTION: Dispose the Lithium Battery properly and keep it away from children.
Replace the Lithium Battery
(Order No: CR2032)
CAUTION: When replacing the battery, make sure to observe the polarity to avoid damage to the machine.
4. Install the Battery Holder into the machine.
5. Close the ADF Door.
6. Turn the power switch to the "I" (ON) position.
NOTE: The service life of the battery is approximately 1 year when the machine is turned "off"

yes you can , depending on what kind of stereo system is in the car, you will need an iso adapter lead that allows your parrot to be connected in between your car audio and power connectors and the car stereo,Similar to this


You need a SOT ISO lead you can check for an installation guide here

http://www.parrot.com/uk/support/installationdiagrams

There are parrot hands free manuals available at http://www.parrot.com/uk/support/userguides/#CK3100

The 3300 is not there but pairing seems to be pretty standard on all the parrot hands free kits. I'd try the CK3100 as it appears to be a very similar kit.

you will need to remove power from the parrot. if the parrot does not power up again fully it will need new software wirting to it. Also try removing battery on your phone, this may be telling the parrot to stay on.

You will need to find the main blue box and unplug for 5 mins. also check live and igition is wired correct. parrot should say disconnected then goodbye when switched off.

With most Bluetooth objects, the code is going to be 0000. If you're not able to get to the code after the Parrot recognizes the voyager, try removing the battery while the phone is still on. Replace the battery, power on, and try again.

here,

When I did this truck I had to go to the amp under the center console. Good luck

#510564: 2007 GMC SIERRA C1500 2DR TRUCK
Audio/Mobile Video
WIRE COLOR POLARITY LOCATION
Battery ORANGE (+) RADIO HARNESS
Accesory (CLASS 2 DATA) (+) RADIO HARNESS
THE RADIO HARNESS DOES NOT PROVIDE A SWITCHED POWER SOURCE. RUN A WIRE TO THE FUSEBOX FOR SWITCHED POWER. THE ACCESSORY TURN-ON AND AMPLIFIER TURN-ON ARE CONTROLLED BY THE CLASS 2 SERIAL NETWORK.
Ground BLACK/WHITE (-) RADIO HARNESS
Illumination GRAY (+) RADIO HARNESS
Dimmer BROWN (+) RADIO HARNESS
Amp Turn On PINK (+) RADIO HARNESS
LF Speaker (+) TAN
LF Speaker (-) GRAY
RF Speaker (+) LIGHT GREEN
RF Speaker (-) DARK GREEN
LR Speaker (+) BROWN
LR Speaker (-) YELLOW
RR Speaker (+) DARK BLUE
RR Speaker (-) LIGHT BLUE
Amp Location UNDER CENTER CONSOLE
Steering Cntrls OPTIONAL
THIS VEHICLE MAY BE EQUIPPED WITH OPTIONAL ONSTAR® TELEMATICS EQUIPMENT. USE AN APPROPRIATE INTEGRATION HARNESS OR INSTALLATION PROCEDURE TO ENSURE PROPER FUNCTION OF THIS EQUIPMENT.
Speed Cntrl OPTIONAL
Radio Security YES

try switching the red and orange wires. one is constant and one is switched. you can try by just reversing them at the inline fuses. hope this helps.