Ctekm200 showing flickering lights, power & mode. Marina have installed temp gen with power intermittent. Is this the cause.

The cables could either be loose or need to be replaced for your TV or the connection ports are broken. The LED lights or the T conn board could be causing the TV screen to flicker.

https://www.youtube.com/watch?v=hAVABiCe6ew
If your light bulbs are flickering, turn off the power and using a glove to protect your hand from heat, screw the bulb in tighter. Loose light bulbs mean the socket isn't making proper contact with the bulb, and that can cause intermittent flickering. Even recessed lights can loosen, so check those connections first.


https://www.cnet.com/how-to/flickering-lights-check-these-common-culprits-first/

separate wiring. touching wires creates cross-talk of signals.

You have to check the ESR in tha caps in power supply with esr meter.
If you dont have one just replace all capacitors in the power section(there are severals of them)This is the simptom of low esr in the capacitors.
Return the monitor in factory settings.

This may just be a problem with the wiring of the car's ECU. It could be a loose wiring. The ECU may be receiving power intermittently. It could also be just an issue with the EFI relay. The ECU signal from the EFI is intermittent causing the flickering and the clicking sound.

Hi Betty

It is a known problem of ccd imager chip failure in your Canon camera. Replace ccd imager chip by local camera repair shop to get correct live image in camera mode. Tell me if the problem is intermittent.
Thanks.

I had to push breaker to one side and then back to where it should be to "reset the stove"..

boot safe mode

ok looks like it is temp dependent -- in most cases you will probably need a new display or have to get yours reconditioned . what normally happens is that the lcd ribbon cable gets a bit loose -between the lcd and the pcb and this causes intermittent faults . also next time it plays up try heating it up with probably a hair dryer-just be a bit careful.this will probably confirm if it is due to temp---or it could be just dry joints ---try tapping it and see if it comes good