Where can I get a users manual for a Eveready flashlight/Lantern model#8209

1 Answer. If it is the yellow floating lantern you have to remove the black plastic stub on the underside of the reflector using needlenose pliers to wiggle and slightly pull until it releases and the bulb will come out. This worked great! Eveready should have this as one of their FAQs.Jan. 6, 2011

How do I change the bulb of the 6V Eveready Lantern? - Fixya

Hi, Check and clean the contacts from the batteries to the lamp.
There maybe corrosion in there. Also the switch maybe bad. Clean and retry. Use a bit of emery paper to clean contacts. good luck.

Drop a couple of drops of WD 40 on the bulb retaining ring. Let site overnight and in the morning it will easily unscrew. Note: be sure you use only a couple of drops as you don't want to get it on the reflective lense

The switch in the lantern is a press fit switch so you will destroy it when you remove it. Remove the lense and retainer ring. Remove the battery. With a pair of pliers, preferably channel lock water pump pliers crush the switch into small piece and discard. Trail Tech makes the exact water resistant switch model 040-ls-b and you can get it at Amazon or on eBay . The switch runs around $6.25 + $4.00 shipping

The question does not make sense since it doesn't pertain to the 6 volt dc flashlight

To test a flashlight bulb you use an Ohm meter which will detect a broken filament or an open circuit within the bulb. If the bulb is bad it will read "OL" if it's good it will read "00.0"

Check that the contacts where the springs on the battery make contact in the light to see if they are corroded. If so scrape or sand them off.

Printed on the side or embossed on the bottom of the cell.

The bezel (the circular portion on the front of the flashlight that holds the bulb and lens) will unscrew. The old battery should slide right out.

Hope this helps.

If it is the yellow floating lantern you have to remove the black plastic stub on the underside of the reflector using needlenose pliers to wiggle and slightly pull until it releases and the bulb will come out.