Reddy r110 starts and runs for 30 seconds. I have tried all the troubleshooting and can't fix it.

Jerry Magee

• 232 Answers
• Posted on Dec 23, 2008

SOURCE: The heater shuts off tripping the reset- motor/fan ***'y is froze

097134-02 try Reddy Parts

Albert Getty

• 547 Answers
• Posted on Feb 24, 2009

SOURCE: flame goes out after 5 seconds

the thermocupple is a small tube that when heated shrinks to let gas flow if it is no good gas will not flow change the thermocupple thank you for useing fixya please rate me

SOURCE: Reddy Heater R 40

im having the same problem. But where are the instructuions on the settings. ie: yellow screw

SOURCE: 150,000 BTU propane Reddy Heater shuts off after ignition

Is there a frost line on your LP tank, if so you may need to replace the tank with a larger tank or refill your tank. This can happen if the tank your using is too low or too small (use 100 lb tank or greater). If there is no frost line it may be an issue with the thermocouple. The manufacturer offers a service manual and owner's manuals on there site. This should assist you... www.desatech.com Thank you

Marc Powers

• 146 Answers
• Posted on Oct 22, 2010

SOURCE: r100 reddy heater, low pressure forced air heater.

The R100 is a kerosene heater and the RLP100 is a propane heater so I am not sure when one you have.
If it is kerosene then you may need to check the pump pressure. Also the Safety swith can give you a cut out after 30 seconds.

If the unit is Propane then you could have a bad control board or a flame sensor.

You can call our service department at 1-800-475-5660

Thanks

Testimonial: "thanks! it is the kerosene heater. i ordered the low pressure gauge and will check pressure. motor cuts out and you hear the safety switch click."