Is my nautilus TC 5000 tread climber belts supposed to move freely?

Hi normally this error is
trouble with the incline motor
Test the motor with 110vac forward and backward
see the schematic diagram, with DMM and see t
The power of the Incline Motor Assembly Part1
Let me know
[email protected]
cell+whatsApp: +50588611441

You would need to contact the manufacturer on this question.

If you wish to get some details; check the site linked here. Pull up older posts.
http://electro-medical.blogspot.com/

If you wish to get some details; check the site linked here. Pull up older posts.
http://electro-medical.blogspot.com/

If you're running the machine on a dedicated circuit then your unit is drawing too much current. This can be caused by friction and drag. Solution: Lube deck/belt. If problem persists, replace deck/belt. If you ignore this fix this will blow your controller. .

You have to realign treadles ,take the back cover out and at the base of your unit you'll see two slides , couple of screws and yellow bushings if bushings are still in a good shape you can align treadles , if they're broken or worn out you have to replace them , I think there are 8 of them total ,they're called IGUS bushing
Good luck

see the video attached. and proceed according. However you must test the power cord for short circuit. some wires is touching each to another. Or the outlet wall the wires are loosing touching each to other and blowing the c.breaker, or call some electrician for to fix it.
God bless you

Nice machine! I use WD 40 on my machine. It comes with a small tube attached to the can that lets you get into joints and bearings easily. Keep the can handy if you work out regularly..it keeps it quiet and smooth!

see the video and proceed according and fix it. God bless you

1= do not panic
2= Lube the deck belt
3= lube the roller bearing
4= adjust the REED switch see the diagram attached, clean and tigh the wires connector very well
5= lube the motor elevation very well gear and shaft.
6= adjust the potentiometer of elevation motor,
7a readjust again the speed sensor, see the diagram attached,clean it and tight wires connector very well.
7= Run again the software calibration for diagnose and troubleshooting
see the block diagram and fix it , maybe the main motor board is faulty, test it with the RUN s.calibration. God bless you