Any input would be highly appreciated - Car Audio & Video

make sure a new amp has a phono input (a sensitive high impedance input)

Connect front the sub out (single) on the amp to one of the rca inputs on the sub, This will work reasonably well but to make the most from the sub buy a 2 rca to 1 rca cable and use it to connect both rca inputs on the sub to the single output on the amp

Place one end of the cable in the socket in the TV and the other end in whatever you are connecting to , perhaps a DVD blu ray player?. Then select the appropriate input or source on the TV remote.
I hope I have been of help but please do not hesitate to ask if you have any further questions.
I appreciate your vote if you appreciate my reply.

No - it is not 2 ohm mono stable

• 1000W max power
• 165W x 2, 20Hz - 20kHz, @ 0.04% THD + N, at 4 Ohms
• 200W x 2, 20 - 20kHz, @ 0.15% THD + N, at 2 Ohms
• 400W x 1, 20Hz - 20kHz, @ 0.1% THD + N, at 4 Ohms
• OTL (Output Transformerless) circuit
• Pulse power supply
• Line & High Level Inputs
• .3-6V Level Adjustment Control (RCA Pin Jacks) 1.2-12V (High Level Input)
• 80 Hz, -18dB/octave Low Pass Filter Switch

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

hat u need to do is drive vehicle until you hear this pitch once you hear it turn steering to the right to see if whine disappears if it does you are looking at replacing wheel bearing.

You can not connect the speaker lines directly to the RCA inputs of your amplifier. But you can connect them to your amplifier if your amp has a high level input. Most of the time it looks just like the speaker jacks of the amp, but smaller. It will be labeled high level input or speaker input. Sometimes an amplifier will have a jack for a wiring harness just for this purpose. Some amplifiers have them and some don't.

If your amplifier does not have them, you can purchase a line level adapter at most anyplace that installs car stereos. it converts the speaker level to the proper level of the RCA input.
Just follow the instructions on how to connect it.

If you try to connect the speaker outputs directly to the RCA input of the amplifier you will blow up the pre-amp in your amplifier.

I hope this was helpful to you, if so a good rating is always appreciated.

Thanks and let me know if you need more help.

Hi Greg,
Again, if you have a high definition dish box with HDMI output,and a dvd player with HDMI output,please connect them both directly to your TV HDMI inputs.
When watching TV(dishnetwork box).remember to switch the HDMI video inputs.
Same as your DVD player,you need to switch it under your TV video input.
solutiondoct

Had the same problem on my norcent 2722 too. Change your PC resolution to 1280 x 720 pixels and try the inputs again.

I agree with your solution and you are correct in that you lose very little quality by using component instead of HDMI. there are A/V receivers that transcode HDMI inputs to component; as far as I know that's the only other option

In short - No. The Eq menu is the only way to affect the frequency levels on the inputs, but if you select stereo buss and listen to the inputs, you can hear the effect of each Eq on the relevant input.