Re: What kind of batteries for the evatac flash light
My Evatac flashlight rechargeable batteries not working .when connecting batteries to charger light flashes green red green red ect. What is the problem
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
If the battery charger on your Evatac flashlight blinks from red to green repeatedly when you connect the batteries to the charger, it could indicate a problem with the batteries or the charger itself.
Here are a few possible reasons why the charger is blinking from red to green:
The batteries may be faulty or damaged. In this case, the charger may not be able to charge the batteries properly, causing it to blink from red to green.
The charger may be detecting a problem with the batteries, such as overcharging or overheating. In this case, the charger may be designed to stop charging and start blinking from red to green as a warning.
There could be an issue with the charger itself, such as a loose connection or a faulty circuit. In this case, the charger may not be able to properly charge the batteries, causing it to blink from red to green repeatedly.
It is recommended to check the batteries and charger for any visible signs of damage or wear, such as corroded or dirty connections. If the issue persists, it may be best to contact the manufacturer or a qualified technician for further assistance.
The flashing green indicator is telling you (and the notebook) that the battery is almost fully charged, but then by switching immediately to flashing orange, the status has changed to "battery charge is low". This is not normal behaviour and probably indicates a serious issue with the battery. My guess is that the charging is initiating some kind of rapid battery self-discharge. Ref - Knowledge Base
Notebooks will power up and work without a battery just fine. Ref - Laptop Battery Basics dummies Try to operate yours this way. This will eliminate the battery from the loop as a potential cause of the BSODs you are seeing.
Kindly remove the battery and sim card from you're handheld and reinstal after few seconds, Even then if it is not working kindly Install BlackBerry Device Software 4.1 version or later.
Water on or in any kind of camera can spell doom to the inner workings and circuits. If the camera ever gets any kind of water inside, the chances of fixing the camera is not good. Something which could be tried when any kind of water gets into a camers's insides is this: Immediately remove the battery or batteries. The reason for this is that the circuits are live when a battery or batteries are installed. This can lead to damage and shortages which will lead to all kinds of circuit troubles.
My suggestion is to sell the camera on a site such as Ebay for parts, as is, or repair parts. The reason is the the repairs more than likely will cost more than you want to spend.
Set the camera to anything except no flash. Turn it off. Take out the battery. Wait 5-10 seconds. Put the battery back in. The flash should now work until you turn the camera off again (and then you must remove/replace the battery to get the flash working again).
The flash requires some kind of "master reset" to work. Haven't found a permanent solution to this.
×