Restart it. Do not turn it off and then on but Restart it or reboot it. If the alarm still on try to find if it is wet somewhere. If it doesn't seem to be wet do it lightly with the hairdryer in a low setting. If it still has the alarm, it is wet somewhere that does not dry easily. Leave it for a few days and check it out again. If the alarm is still on, time to take it for service/repairs
SOURCE: My Creative Zen Mozaic 4GB won't turn on
Use the reset button located on the left side. Worked for me!
SOURCE: Power outage last night - alarm sounded. Turned
hi..OK 1st step open the unit and find the memory from the board remove the memory then make clean the all pin connectors using a paper eraser.if u have video card remove too then same make a clean..good luck and have a nice day...Thanks
SOURCE: microwave stopped working last night
If the microwave worked for a little while after you plugged it in again then it is just overheating.It is usually just dust/dirt collecting on the vents.the fan,and the magnetron(the thing the fan blows on).If cleaning all these doesn't solve the problem you may have a bad high temp overload sensor,and need to replace it.(this sensor is usually mounted directly on the top of the magnetron.The magnetron is the part that actually puts out the microwave signal.I've never seen a reset button.The high temp sensors reset themselves automatically.
SOURCE: Samsung DLP TV HL-R5067W green vertical bars on screen no picture
This is going to be a bad digital board. It is a very common issue with the HLR series.
SOURCE: Norelco 835rx unused for 10 yrs, worked 1st time, then not.
The battery pack is, likely bad and will need replaced. Batteries don't hold up well sitting around for 10 years. The stress of charging may have finished off the batteries completely. When the batteries short out internally, the shaver wont run from the cord either. Before ordering batteries you'll want to make sure the old ones have not corroded badly and ruined the circuit board. To check it out, remove the four screws on the back and remove the back cover. Lift out the circuit board and inspect it to make sure there are no burns.
If everything looks to be in good shape, installing a new battery pack will probably be all you need to do. You will fin the correct battery pack at shaveroulet.com. See link below
http://shaveroutlet.com/shaver-battery-pack-for-most-norelco-more-p-278.html
147 views
Usually answered in minutes!
×