My kenwood kdc-mp342u is in protect mode and i cant get it to reset

SOURCE: Kenwood KDC-X492 where is the reset button????

if you have the excelon
then its in between the aux input and usb interface

SOURCE: protect mode

Press reset button (small circular button need something with a point) to the left of the 1 channel

SOURCE: how can i deactivate the protect that blinks in my

Disconnecting the terminal will take to much time.. In between the skip button ,and the #1 on your stereo there is a little dot. Barely noticable unless you know what your looking for, take a safety pin or a screw( anything with a little tip) and push it in. This will restart your stereo. (Car Must be on)

SOURCE: I have a Kenwood car stereo model # KDC-MP342U.

hold down preset 3 & 6 + reset
press preset 1 - shows dc err
press preset 1 - shows dc ok
press preset 2 - shows dc 2-4
press preset 2 - shows dc 2-0
then unit should be ok with eeprom reset

SOURCE: Kenwood KDC-MP732 CD Player in protect mode how do

Protect Mode (Blink): The speaker wire has a short-circuit or touches the chassis of the vehicle, and then the protection function is activated.

Solution: Wire or insulate the speaker cable properly and press the reset button.

Here is a copy of the Instruction Manual for the Kenwood KDC-X790 and KDC-MP732.

I’m happy to help further over the phone at https://www.6ya.com/expert/jeremy_69f3cc28d95bf514

Instant Repair Help over the Phone

6ya.com

Save Time & Money by instantly connecting to...