What are DJ Headphones good for? - What Are Audio Players & Recorders

gotta clean the silicone pad inside, you got carbon settling down there. Take it to a shop, is my best bet. Many ways to clean and restore these pads. Luck.

If you go to the outdoor technology website in the FAQ there's a link for replacement cords, 5 dollars including shipping.

If you are using virtual dj , adjust your settings under configuration - sound setup , change the output settings to headphones.

my skullcandy headphones speaker bust a while ago so i replaced both of them, so its the same concept of changing wires or wateva(cos i had to change that to as i wanted to extend it.) its alot more complex then it looks, but mine came out fine, so if you cant find a place to fix it it is possible to do it yourself, note that the screws are under the ear cushion witch can twist of.

if your desktop has two audio outputs (one for headphones and the other one to connect the speakers - both green), then you dont need dj io (or a second sound crad on the side), just go to config and chose the sound card settings to double inputs and in outputs chose both speakers and headphones' depending on what software you are using.
questions [email protected]

Have a look at my tip on cable/plug problems for headphones. It might help you solve the problem.

Hi, is there any need to get a new one when it is just only one month old?, doesn't it have any guarantee with it?.

You can simply take it back for replacement and start you can start using you headphone again and continue doing the DJ thing.

Take care.

Hi, I suggest you to contact the Logitech support for a replacement this is an hardware failure and it's covered by warranty terms.
If you are not under warranty you still can contact them as I know for instance in Europe they can offer you some good deal on nowadays products.
US/Canada support: http://www.logitech.com/en-us/contact
European support: http://www.logitech.com/en-gb/contact
Thanks and have a nice day ! J -

hi dj23 Ive have the same problem with mine but i was lucky to find the screws that undo the headphones their are just behind the right hand side headphone under the black bit that touches your ear theirs 3 screws hiding behind the coving with little arrow marking their they are but be very careful as you open it up as the wires are very bake able in side as their is not much room to get in their to fix them i am still trying to work out the best way to put a new wire on to them as the wire that comes with this headphones are not fixable as its unsleved and its the string in side the outer flex that stops the wires touching each other good luck it fixing them please let me know if you get any other info luck jagged

Theres a good posibility that the solder connections are the only thinbg wrong with the connections BUT theres a possibility that the Printed curcuit board its self is a flex board and that the flex connections are torn. If thats the case you probably wont be able to fix the unit. If you can open the unit then you can look at the connections and see if its just plain old solder connections?? Good Luck