Older sbw 3501 blade lenght - Saws

this is the delta model manfacture is china.its blade lenght 16 inch.

older viking have large round nut with 2 holes
you can insert needle nose pliers into holes to turn
you can also use pipe wrench on round part of nut
if the nut is seised on you may have to drill out and replace nut and jet holder that nut screws onto

Tutorial on Changing Band Saw Blades

HI
I HAVE KONICA C6500
ERROR CODE 3501 and 3802 but know the error 3501
I know it rech high temperature I change the sensor 1 UP fuser roller
and I reset the error, the machine start and stop again with error 3501

Trevor, I do not know the answer since I do not own this model of a pickup truck but this is what you need to do. If you look at the wiper arm you will note that it is hinged which allows you to pull it up off the windshield and stay in place with the wiper blade being at right angles to the arm.

At this point, you can simply use a tape measure to find the lenght of the actual blade. That number will be accurate when you go to get replacements as the lenght is marked on the package.

Inside parts:
Small belt wheel (SBW)
Large belt wheel (LBW)
Motor Assembly (MA)
Fan Blades (FB)
Fan Blade Cover (FBC)
Make sure you have magnetic screwdrivers.
Remove MA - 4 screws.
Remove FBC - three screws
Loosen LBW and slide down shaft a small bit away from end. Need small Allen wrench.
Slip new belt around LBW (takes some fiddling).
Put LBW back to previous local and tighten.
Reattach FBC.
Put motor in place.
Stretch belt over FB and onto SBW. (It will make it.)
Screw in motor.
Good luck.

Hardware error

Error Code 3501
Error Code 6203
Error Code 6203
Error Code 3501

on older vcr's there should be a sp/slp or ep button on your remote or vcr. if not when you set a program to record, the option to choose should be there. sp= 2 hrs, ep =6 hrs.
wg

Here you go: xg-2000: http://www.geminidj.com/disc._prod_manuals/AMPS/XG-2000/XG-2000.pdf PMX-3501: http://www.geminidj.com/disc._prod_manuals/MIXERS/PMX-3501/PMX-3501.pdf Hope this is what you want