Where can I order a remote transmitter for a intertherm Bdm35 gas fireplace

Christopher, You may need to remove glass or it may be hinged and swing open.I will post links on how to relight pilot below.
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."

Fireplace Pilot Light Tutorial


https://www.google.ca/url?sa=t&rct=j&q=&esrc=s&source=web&cd=5&cad=rja&uact=8&ved=0ahUKEwiKmrfMyZjLAhVMLB4KHSvqDPQQtwIIMDAE&url=https%3A%2F%2Fwww.youtube.com%2Fwatch%3Fv%3DEqhBzX3YDcw&usg=AFQjCNEyzETy1RKmpSule9U_CquiVcXUIQ


How to light pilot light on gas fireplace Canada Furnace 604 210 7771

How do I order log set for my BDM35 propane gas 69L6901

Every time the batteries are changed in the receiver and transmitter the transmitter has to be "re-learned" to the receiver. To do this locate the "learn" button which will look like a tiny hole so you have to stick the end of a pin or a pen in the hole to press the button. Hold the button down until it beeps at you 5 times and release. press the button again and release and then press Any button on the transmitter.
Once the receiver is set into its "learn" function it does not matter what button is pressed on the transmitter because the next signal the receiver picks up will be the frequency it is attached-to.
In order to change the transmitter simply hold the learn button down until it beeps 5 times again which tells us it has wiped out its memory. Then press, release and press the transmitter.

If you want to check if your remote is working and you have a cell phone that takes pictures hold the remote in front of the camera and when you have a pitre of the remote press the button and you see it on the camera if you don't the remote is not working hope this helps (this goes for all remotes ) Tom

Check the thermocouple, it generates the electrical power from the flame of the pilot to open the gas valve.

you must download the code go to www. remotecodelist.com or use your code from you owner manual download from www. retrevo.com

and follow the steps for to do it again.

God bless you

It could be that your transmitter is bad. You may want to try to re-sync the remote to the fireplace. Slide the Remote/Local switch on your valve from remote to local, then back to remote. Within 10 seconds press the flame button on your transmitter. This will establish a new frequency connection between your transmitter and valve. Good luck!

could be thermocuple or pilot blocked clean pilot then try make sure you are turning to on and not back to off i was doing this the other day some go clockwise some anticlockwise

its already adjusted. I suggest you don't play with gas. If your having a problem call the gas company.