Is there makita 9553nb service manual - Makita Saws

My first thought is the power switch. is shot.

Any nut with the proper threads will hold the disk on. Any hardware store will what you need, just take the grinder with you and try a few.

first unplug the tool, next on the backside you will notice a screw, remove it and slide the cover back to expose the backside of the motor. gently move the springs that hold the brushes tight to the side and remove the brushes and replace. Make sure to replace the springs and then slide the cover back into place and replace the screw and that should take care of your problem.

Hi,
Yes, that is usually the brushes, they need to be replaced...

heatman101

as its a grinder...there are not many attachments available....just your common grinding and cutting discs.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/sean_54c3a3dc48a7773c

are you using the proper inner blade flange?? that is the only thing that I can think of that would cause your problem

You need the 4" rubber pad, Makita Part #743009-6. It can be found on websites like www.ereplacementparts.com.

Your missing the flat wrench that goes under the blade and holds the shaft from turning. I can't find anywhere to buy just the wrench. If you can find an old 14mm wrench and grind it down on both sides so that it's only about 1/8 of an inch thick it should work.

try looking hear.http://www.toolpartsdirect.com

brushes ant be repaired. They have to be replaced. unless dirty you can clean them if they are not making contact witht the armature. There should be two round circles near the hand grip with like a coin slot on them. Just srew these of with a screwdriver.