For an E7 fault the PCB has to be reset:
1. With the door open, turn the appliance 'On'
2. Within 3 secs, push the program selection button 'P' 4 times
Good Luck Clive
See this: http://www.fixya.com/support/t25937477-error_codee7
SOURCE: ERROR CODE E7-03
E7-03 indicates hard drive trouble. the hard drive is going bad. There is not a whole lot you can do besides trying to reseat all connectors for the hard drive (the harness/wire from the HDD to the ICU PWB board) otherwise replace the hard drive.
SOURCE: sharp ar-m205 error code E7 11
U HAVE TO UPGRADE THE FIRM WARE BY ENTERING SIMULATION 49-1 THE VALUE IS d THEN UPDATE THE FIRM WARE IF U HAVE IT
SOURCE: cannon pixma mp145 printer error code e7 & e2
E2: Reload the paper correctly and press [Black] or [Color].
E7: The cartridges are not installed in place.
These are from the manual.
SOURCE: error code E7
Dear Sir:
This error is normally associated with1) Elevation Motor problem.2) Display doesnot light up
1)tigh the connector from elevation motor and clean 2) Adjust the Potentiometer 3) Lubricate the gear 4) Test it.
2) Adjust the Reed switch see the diagram attached 3) tigh the connector very weel and clean the reed s.and reset.
sincerely. God bless you.
314 views
Usually answered in minutes!
×