How do I change my Toshiba TV from Analogue tv to Digital tv?

yes an adapter

if the tv does not have a built in hd digital tuner you need a Hd digital converter to analogue converter. What you need to be careful about is the available inputs on the TV if it only has AV in then you need a converter that transmits out RCA video or an analogue tv channel on RF the tv can tune into. Some of the new converters have HDMI out so if TV does not have HDMI input it won't connect. The antenna would go into the converter. Not sure how much signal you need you may need an rf amplifier if the signal is poor in your area.

there is no code you need to buy a set top box to convert analogue signal to digital

If the TV set is on the same stand as the Sky box then you don't tune at all. Connect with either a HDMI cable or a SCART. Use the AV input on the TV.

If you mean you have a bedroom set, and Sky is piped around the house on RF, then that's something different.

Make sure your TV has an analogue tuner as well as the digital one used for Freeview. (check the remote for a TV/DTV button). Go in the the TV tuning menu, and do an Auto tune for both analogue and digital.

Hi
On my set I just hit the input button 'TV'. By pressing the 'TV' button again causes the TV to toggle between Analogue and digital.
On my Panosonic I have buttons on the remote labelled input, with a sub selection of either AV or TV.

regards Jacko
Downunder

I doubt it has a digital tuner but the owner manual should show that or Google the model number.

Hello
Thei Orion model Tv is not equipped with a digital tuner inside. There is only an analogue tuner fitted and only analogue channels can be received by this set. To get digital channels, you have to buy one settop box, which can convert digital signals to analogue signals. In short, a Digital to Analogue Converter should be bought, if you want to get digital channels. OK.

If your TV is an older variety that wasnt set up for digital signal you will need a set top converter box.

I had the same until this mornin. It installed the Freeview channels (we no longer have an analogue signa), and we loved it! Since then, "no signal". We also DO have a Freeview PVR, so we could watch through the EXT1 sourse.
The "Source" button on the remote control handset offers you input option (TV, DTV/USB, DVD, etc etc). I was using TV, which is for ANALOGUE signals. I have just selected DTV/USB and omg! success!! And relief!!!
If this sorts you out too then my work is done. x

When installing the tv channels, the system must search for analogue and digital channels. It sounds as though it didn't complete the installation procedure.
Let it try again.
Hope that helps.