I am locked out of my PLDN70U Pyle stereo, even, using 0000 and 1234 codes with a reset press. What other options do I have?

press and hold DISPLAY button until numbers start blinking on display screen use volume knob to change numbers press volume knob to switch from hours to minutes press DISPLAY when done

HI,

First try these codes.
1234,0000

there is a rest button on every car stereo deck it is small u just have to press it in n hold for 5 sec than system will reset to factory setting

Use the audio out from the TV to the audio in to your receiver

TRY PUSHING YOUR RESET BUTTON. THE PLAYER WONT DO TO THINGS AT ONCE. IT WONT PLAY A DVD WHILE PLAYING YOUR I POD

Hello
If a power interruption occured to your household power supply, V-Chip has to be resetted. To reset the V-Chip do the following.

Channel guard and V-Chip settings are protected by a four-digit lock code. Your TV comes

preset with a lock code of "0000". You may change the code to any four-digit number you wish.
To change the lock code, follow the steps below.
Press the MENU button
To SET LOCK CODE use UP/DOWN buttons.
To operate (lock icon appeares on pressing =>/ Press ZERO to access the lock code
The first digit will be highlighted
Use =>/<= button to
To select the number
Press Up/Down button to
To move to the next digit
Continue to follow these directions for all four numbers
Press the OK button to finish (your lock code is now set)
Press the Menu button when finished
OK. Thanks for using Fixya.

factory default Lock Code is 1122, 0000,1234, etc

Hello lizskates814,

You can use either the high level (speaker) or the low-level (RCA's) inputs to the amp, but not both. Choose whichever one sounds the best or is more convenient to install and leave the other disconnected.

Hope this helps.

if you have not set a personal pin then the default codes are 0000,1234,or 9999. if you have a personal code then the only way to access it is to contact the service provider and have then reset it from their service center, good luck please rate this thanks...

type in ##3282# then go to advanced, view and scroll down till you get to lock code and the code will be displayed