Long 460 tractor. Rear hydrauliclift does not work.

firing order of 1342, rotor turns clockwise when viewed from the rear

look at the instructions again and if it still doesn't work bring it back and explain to the person what happened

I own one. Most have a plug in the top of the trans/hydro case to the left and rear of the gear shift leaver. It takes a 3/4" drive to open it. I use an extention and brake bar or ratchet. The fluid should just all most reach the opening. the books state it should hold 8 to 10 gal. I have found my 460 Utility holds almost 20 gals.

I have a International mid sixties 460 tractor. Have drained fuel, changed fuel line and filter. Carb has been taken off cleaned no issues. Will start and run for a few minutes sometimes longer than others. Seems like there may be an issue with the governer. Any ideas what to try next. Thanks

ther will be acover on rear deck plate next to shifter this is the fill hole check plug will be onleft side of rear end housing under clutch rod [pipe plug] fill until fluid drips out check plug

i am not sure but check the levers and the inside of the lever control movements.

check the carb out clean it and the lines also just to be sure check the sparkplugs

universal hydraulic fluid is all we use it is used for the transmission and the hydraulics, about 25 bucks for 2.5 gallons, put in at the gear shift until it comes out plug below cluch pedal. Check any cenex gas station .

Try the experts over at Yesterdays Tractors.

I currently do not have a 460 rebuilt carburetor in stock but I can rebuild the one you have.