My machine is not coming on have check the socket and put new fuse in plug but none of the lights on the front are lighting up It's a Bosch Maxx WFL2260uk/04 worked fine last time I used it

SOURCE: Bosch Maxx WFL 2260 not draining - nothing in filter - help?!

sounds like a simularproblem i had, a 5cent piece got caught in the drain solenoid (just between the drum and solenoid) , i had to lift up the front and spin the drain pump fan, on empty, then disassemble and clean pump assy and remove 5cent piece, hope this helps.

SOURCE: washing machine went bang and wont work. The plug fuse is fine and the washing machine light comes on but it wont work

Changes are you broke a "drive belt".
It snapped causing the noise.
Lift the top up (easy if you pry a bit on each corner).
You will see the broken belt.
Remove the old belt and take it to a shop to make sure you get an exact replacement.
Threading the new belt can be a tiny bit confusing but it will soon become obvious.
It is like the "fan belt" in a car.

Gerry Harvey

• 1482 Answers
• Posted on Sep 28, 2009

SOURCE: Bosch Maxx - softener not dispensing into machine

It blocks very often , give it a good clean..remove soap dispenser to do so

SOURCE: Bosch Dishwasher Maxx classixx Model S9H1B

look carefully at operating buttons they will have 2 marked with a line with dots at either end, open door press and hold these 2 buttons usually 2 and 4 as from left too right, turn on keeping fingers on these buttons after a few seconds end light will come on turn off at main switch then back on again should work after that.

SOURCE: HP G60-230US lap top won't turn on

This issue could be due to presence of static charges or internal hardware malfunction of the notebook. To isolate the exact cause of the issue, perform the steps provided below.

Step 1: Hard Reset

To perform a hard reset, please follow the steps listed below:

1. Unplug the AC adapter from the notebook PC and remove from any port replicator or docking station.
2. Remove the battery from the notebook battery compartment.
3. Press and hold down the power button for about 20 seconds.
4. Insert the battery and plug the AC adapter back into the notebook PC.
5. Press the power button to turn the notebook PC back on.


This will discharge the static charges from the notebook. Now turn on the notebook and check for the issue. If the issue persists, then remove and reseat the memory modules of the notebook and check for the issue.

Step 2: Remove and Reseat the Memory Modules

You can refer the service manual provided below for information to remove and reseat the memory modules of the notebook.

http://h10032.www1.hp.com/ctg/Manual/c01602064.pdf

Refer page no: 52 & 53
NOTE: PDF manuals require the Adobe Acrobat Reader for viewing and printing.
If the issue persists after the above steps, then this could be due to internal hardware malfunction of the notebook and requires a detailed onsite diagnosis by a service technician. If your notebook is covered under HP Standard Warranty, then I would request you to contact HP Support to get your notebook repaired under warranty.

I believe the information provided would be helpful to isolate the issue with your notebook.