We is the fuse located in a hitachi cpx2530wn projector? Are do it have a fuse? Because the projector is not turning on.

https://www.google.com/search?q=DIODE+T3D+36

https://www.google.com/search?q=HITACHI+CP-X3030WN

Original Projector Ballast Main Power Supply For Hitachi ...

AliExpress https://www.aliexpress.com > item
Original Projector Ballast Main Power Supply For Hitachi CP-X3030WN. 1/1. 1. US $52.62. Price shown before tax. Free shipping?Free returns. Original Projector ...
US$52.62

Projector Power supply For CP-X2530WN CP-X3030WN ...

AliExpress https://m.aliexpress.com > item
Projector Lamp Ballast And Power Supply For Hitachi CP-X2530WN. US $80. Projector Lamp Ballast And Power Supply For Hitachi CP-X2530WN. EUC 215g N/T05 ...
US$50.00

CP-X2530WN/CP-X3030WN CP-WX3030WN

Projector Central https://www.projectorcentral.com > pdf > projecto...
power supply make the projector turn on. Setting up. ?This product is also designed for IT power systems with a phase-to- phase voltage of 220 to 240 V ...
118 pages

....

This unit uses a DC to DC converter, and it is very sensitive to voltage spikes, it does have a fuse on the power supply and it also has 4 solid states fuses that look like transistors and resistors on the power supply board.

Tony

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/tony_a41fa0b801734e2f

This projector was sold with a 3-year manufacturers warranty. You can contact Hitachi warranty service at 1-800-HITACHI.

If you have a continuing issue or support problems, contact me directly at [email protected].

There is not physical reset switch. There is a switch to the right of the vga input but this is only for when you can't shut it off. i would check a fuse in the power supply to see if it has blown it should be located near the power input plug. you will need to open the case up to see this.

try looking for your thermistor usually located near the wind path its a small block the size of two match heads usually mounted off the main board with two wires this is your 'heat switch' so to say, also check your fans are clean and running there is normally more than one.

Hi,

Make sure the Computer Input is set to VGA, Computer, or RGB (depending on which projector model you have). Go through the menu settings of your projector.

Hope this helps

The internal fuse is normally located very near the power plug socket and usually a Buss glass fuse, rated 5 amps? If you get to it, check the metal end for the rating.You have to remove the top cover to get at it...remember, the problem could be the fuse--or the power supply section has failed.--Rick

whats your location, The power supply is faulty, but fairly easily repaired, if you send it to me, I will sort it out

ok " sounds like you have a short, thats why it's blowing fuses