Question about Life Fitness Exercise & Fitness

Open Question

My life fitness elliptical, model with alternator starts control panel and after a few minutes it pauses and then shuts off no matter how fast you are going. There is not a battery as that’s what I though was the culprit. Any help would be appreciated.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

SOURCE: Gaggenau GI 936-760 dishwasher

Buy a new one and sell me the door. I have been looking for this model's door for a long time!
williamduck@comcast.net

Posted on Dec 12, 2007

Ad
  • 1 Answer

SOURCE: i cant seem to turn off my zune completely, only pauses

The Zune never really turns off completely. To turn it off, hold the back button and up on the Zune pad. As soon as the screen turns black, let it go, and turn on Hold.

This will turn it off completely.

Posted on Apr 16, 2009

vpaaf
  • 115 Answers

SOURCE: 9100 life fitness treadmill

Sounds like you need a new lower board replacement. You can get that for that treadmill by call lifefitness or sportsmith.com Please rate me good

I’m happy to help further over the phone at https://www.6ya.com/expert/howard_079189dd4959a511

Posted on May 01, 2009

  • 1 Answer

SOURCE: LIFE FITNESS elliptical 9500HR SHUTS DOWN

I don't know about the answer, but I seem to have the exact problem!

Posted on Feb 17, 2010

maxtreadmill
  • 832 Answers

SOURCE: Where is battery located for Life Fitness 9500HR

These units are not self generating unit theirpower cords is in front bottom if it is missing then you will a power module got to www.sportsmith.net goto life fitness and get pricing

Posted on Mar 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I changed the 6 volt battery when i connect the battery leads and used machine i press clear/pause button it will start again. I have to disconnect the battery to turn it off


If no key is pressed for 15 seconds, and the user stops pedaling, the console shuts down. You can also do the same when starting the machine, just step on the pedals to get them moving and the console should light up.

Dec 13, 2014 | Life Fitness 9500 HR Crosstrainer Rear...

1 Answer

Life Fitness 95xi elliptical electronic panel will turn on but after a few seconds the screen goes blank and evenutally starts back at start up screen.


I would suggest verifying 6 volts output from the battery. From there, check the reed switch connection on the power control board. Also verify the gap between the reed switch and the magnet on the pulley. It needs to be close enough to the magnet to get a good reading. I am attaching a link to a video that shows the reed switch replacement procedure. You can see the magnet and also the slots in the reed switch that allow the adjustment. LifeFitness 95Xi Crosstrainer Video Reed Switch Replacement Speed Sensor

Mar 18, 2014 | Life Fitness 95xi Elliptical Crosstrainer

1 Answer

Electrical issue.


check the battery or alternator that charges it. battery is usually front end and alt is in the back. if this is not it it could be the the controller board

Mar 18, 2014 | Life Fitness 95xi Rear Drive Commercial...

1 Answer

Where is the battery on the life fitness 95xi


The battery is located in the front of the rear drive mechanism. It is mounted just below the alternator control board. The following video shows the battery location along with the battery replacement procedure. Battery 6 Volt 2 5 Amp Hr LifeFitness 0017 00003 0685 SPORTSMITH net

Dec 29, 2013 | Life Fitness 95xi Elliptical Crosstrainer

1 Answer

Life fitness 95XI elliptical clanks


You may still have the original tie rod design on your machine. If so, more than likely this is your problem. The link below is the updated fix for the original design.

Control Link Kit LifeFitness GK62 00002 0071 SPORTSMITH net

Dec 16, 2013 | Life Fitness 95XI Elliptical Trainer...

1 Answer

95xi machine goes into pause mode when being used.


Check the gap between the magnet on the drive pulley and the reed switch that is mounted to the frame.

Aug 05, 2011 | Life Fitness Remanufactured 95Xi...

Not finding what you are looking for?
Exercise & Fitness Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Life Fitness Exercise & Fitness Experts

Vincent_G
Vincent_G

Level 3 Expert

2360 Answers

Craig Butler
Craig Butler

Level 3 Expert

1730 Answers

Android Man
Android Man

Level 2 Expert

278 Answers

Are you a Life Fitness Exercise and Fitnes Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...