SOURCE: Machine stops and sews in place
sews only one stitch at a time and have to wait a few seconds before it will do this
SOURCE: Thread in needle or bobbin keeps on breaking
The tread only breaks in the needle. what can i do . i don't get to sew anything . I tread the needle and get everything ready and start the machine and as quickly as that the tread is broken and the machine has not sewn at all.
SOURCE: I have the Scandia probably 5 yrs old...feed dog
The feed dog motor needs re-calibrating. If recalibrating does not resolve the problem, the feed dog stepper motor may need to be replaced. These tasks have to be done by a certified Husqvarna Viking service technician. Suggest that you take it to an authorized husqvarna viking dealer for service. You can locate a dealer near you by visiting the husqvarna viking website and clicking on the Dealer link on the left-hand side of the page - http://www.husqvarnaviking.com
Good luck.
SOURCE: Needle moves up and & down and sews for a few
If you look at the website, www.sewvacdoctor.com and you can see, they say it may be your foot pedal or transducer(speed control inside the machine) I would call Singer and see if it is still under warranty, hopefully it is. If it is the foot controller, that is not too expensive, I don't know about the transducer. But, call Singer at -800-4singer and tell them what is happening. Good luck
46 views
Usually answered in minutes!
×