My amana model Ntw4605EWO wont fill with water,lights dont come on,just a motor running noise

SOURCE: motor noise

it could be something caught in motor empeller IE. a bit of glass, or motor could be faulty

SOURCE: water from dispenser slows down while filling cup

If your water is slowing down the screen on the water valve may be stopped up or the filter (if it has one, when was it last changed?) or line feeding the refrigerator may be stopped up or the water valve its self may not be opening all the way and staying open.

To eliminate 3 of the external problems take the water line off the fridge and run some water into a pan and open and close water like at your kitchen sink and see if the water slows or speeds up noticeably while running into the pan. If so the problem is in the water line. While you have thew line off remove and inspect the water inlet valve screen and replace the hose washer (if so equipped) this brings your problem if you have not found it yet to the inside of the fridge. Usually on the corner of the door hinge the water line makes a turn up to the dispenser inspect it there and see if its twisted or kinked. Also there is a water resiviour inside the fridge look there for the same thing and possibley where food may have been forced agianst the line.

If you still dont find it by now I'D have to know what you did find and where.

If this helps you please rate me with as high a rating as you can and thank you for using fix ya.

SOURCE: drum isn't spinning but motor is

check inner tub fastens, if they check ok, replace the transmission. note: you will need special tools to change this, if you have them great, if not, you would be better off calling a&e factory service for the repair, 18009059505.

SOURCE: Kitchen Aid dishwasher model KDC-18 is not filling with water

Under the machine is the water inlet valve. if you take off the front end of that you find a filter which fills up with rust, and you can clean it out. If that doesnt work, repairclinic.com will sell you a new valve for 32

SOURCE: water runs but doesn't fill tub and wont spin if put on spin cycl

The drain hose must be higher than the tub of the washer so many times I get called to find the hose on the ground to the drain an this will not let the tub fill.