My Memorex mvdp1088 turns on (green light) but no screen and the disc doesn't spin ave switch is in the out

SOURCE: disc not spinning browser/configuraion display on screen.

1. Check to see if a Music cd will spin in the console
2. Open flip lid and examine the reset switch - check to ensure the switch is intact - you are looking for a small lever which is made of lack plastic. If its not there you need a new reset switch
   
3. If the laser is not moving at all you will need to open up the console (WILL OBVIOUSLY VOID YOU WARRANTY!)
4. Check the PCB switch at the rear of the console. This part connects to the lid of the ps2 if thats is broken you will need to replace - difficult to source but they are available
5. Check the ribbon cable underneath the PS2 Laser for any signs of damages
6. Check the ribbon cables x 2 which attach the laser assembly to the motherboard
7. Remove the motherboard metal shield and test the SMD (SURFACE MOUNTED) on the underside of the board use a multimeter for this
8. If your console passes all these tests the most likely cause is a blown laser which is a simple part to source via ebay etc.
9. If your new laser does not fix your problem then you have a blown RS2004 chip which is expensive to replace and usually not economical to do.
   

SOURCE: On switch button turns green and immediatley turns

Can you hear the fan spinning on the inside of the PS2? If the PS2 comes on, loads the disc, then shuts itself off, chances are it is overheating and shuts off to prevent damage. There is a small fan on the inside of the Slim PS2 that keeps it cool.

If you press the reset switch and it goes from red to green and immediately back to red without ever turning on, your motherboard is shot. ESD damage.

SOURCE: Have suffered YLOD and self repaired succesfully.

dvd cds run normally bluray freezes after 1 or 2 mins. i cleaned len an same problem occured on ps3 no overheating no dust