Connecting the kaoss pad 3 to my built in turn table mixer

Try www.rswww.com (RS/ Radio Spares). They are normally really good.

Sounds like this Presonus is causing alot of people issues. Its not your pad thats the problem i think presonus needs to update there stuff. Im seeing alot of questions on here about PreSonus and there all the same. Contact them and ask them whats up, especially after paying so much for it

We can't guess what type mixer you might be using, HOWEVER check if the units are compatible by verifying that both either have or don't have balanced interconnections. If the pad is unbalanced and the mixer requires balanced lines, when you plug this in you will get a 6 Db drop (reduce to 1/4th power). It may not work at all when not on bypass. Check the specs in your user manual of the mixer, whatever model it may be.

The Mini KP generates Stereo output and you would run it to either a stereo channel on your mixer before the amp or into two channels of your mixer board and PAN them to opposite sides.

If you try to connect this to a monaural amp, like a guitar amp) your cable will ground out the output of this box. The minimum would be to builld a special resistive mixer to combine the channels before they go to your amp HOWEVER you will lose much of the effects without having a stereo system.

You haven't got a send and return on your cdmp 6000. What I advice you to do is the following: connect the master out, the red/white cinch, to the input of the kaoss pad. Than connect the output of the kaoss pad to your speaker system or reciever. You can now control effects on the master single.

I'm having the problem too...I'm thinking that maybe getting the DC adapter MAY fix it though as stated in the Manual: "...The output level of the mini-KP will be smaller than its input level. This is because the attenuator circuit is connected at the input section, considering that the mini-KP is used on battery power." so maybe the dc connector will increase output volume?

Try running it in your FX loop ( out of the mixer into the Kaos, out of the kaos back into the mixxer or out of the mixer into the kaos and out of the kaos into your amp.

I have the same Kaoss Pad mini and have exactly the same problem. I have asked for a solution as well!

The only way I have been able to use live is to turn up master on mixer to compensate, but this is incredibly hard to do if you're not always going through the KP as you have to adjust master volume each time up or down.

I haven't heard any volume problems with the full size Kaoss Pads, think it might just be a KP mini problem.

johnclark

For dj use, industry standard would be something like a Pioneer DJM600 mixer. 4 channels w/ effects and a mic input. To use kaoss it's best to go into Send/Return input through the effects. By tapping on Send, all sound is sent out to the kaoss pad, and comes back into the mixer into the Return inputs. By doing this you can have the kaoss pad on sitting next to the mixer ready to apply effects all the time. Then connect the master outputs from mixer into your amp, or straight to powered speakers. Kaossilator is more of an instrument than effects unit, so plug in to channel 3 after your 2 cdjs in channel 1 and 2. You still have a spare channel left. I use 2 x 1200s and 2 x cdjs with kaoss pad through effects channel in this way. A 4 channel mixer is plenty.

simple bro. . .. flick the korg kaoss pads setting to send . . u will find this on the back. . . i thin you have it set to direct. . flick it over to send and then let em know if it works. . . and could u answer ASAP what cords you used to connect the kp3 to the send return on your mixer. . .thanx

Dj Nap