Question about Leviton Electrical Supplies
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
yes, if the three switches are all made together, then there is only one feed. sounds like a bad switch, or possibly bad exhaust fan. check voltage at fan with switch on, if not qualified, be careful, or call an electrician
Posted on Aug 14, 2008
Wiring a bathroom combination vent, heater, light 3 way switch means more wires. In brief, you need to run two cables - one a two wire and one a three wire from the switch to the fan.
Incoming power will have white black and ground.
The two wire cable for the switch to the fan will have wht, blk, and ground.
The three wire will have red, blk, wht, and grnd.
The switch will likely have 2 blacks and a red coming from it, with two blacks and a red on one side, and a single black on the other.
The fan should have a red, blue, green, black, and white.
On the fan end: Group all green/copper grounds together and use a wire nut to fasten them together. Tape the nut to the wires.
There will be five white wires coming through. For ease of handling, using wire nuts, connect two on one nut and three on the other.
connect the blue to a blck. Connect one red to one black, and the other red to the other black.
The switch will have one red going into the 3 wire cable, a black going to the 3 wire cable, and a black form incoming power to the side opposite the 3 wires, and a blck going to the two wire cable.
Posted on May 28, 2009
remove white switch one and connect to incoming white ground--all whites should be connected [hooked] together these are grounds-- switch 1 black from fan ,leave switch 2 red from fan ,switch 3 vanity black
Posted on Feb 22, 2010
I suggest you cut 3 pigtails out of your black wire (about 5-6" each and strip them so you can put a nut to tie them all together on the main wire, then do the same for your grounds using green 5-6" strips of wire and then connect all 3 switches with the pigtails to their proper locations. This WILL fix your problem.
Posted on Mar 09, 2010
Tips for a great answer:
Aug 30, 2014 | Leviton 5634 Dual 1 Pole Switch Decora...
May 16, 2014 | Leviton R03-5634-A Two Single-pole...
May 14, 2014 | Leviton 5634 Dual 1 Pole Switch Decora...
Jun 09, 2011 | Leviton 5634 Dual 1 Pole Switch Decora...
Feb 24, 2011 | Leviton 5634 Dual 1 Pole Switch Decora...
Oct 28, 2010 | Broan-NuTone P66V Fan Control Switch
Mar 08, 2010 | Leviton 1755 Triple Rocker Switch Decora
Apr 10, 2009 | Leviton 5634 Dual 1 Pole Switch Decora...
74 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: