My beurer body weight scale. When I tap it with my toes it reads 88.88 and almost immediately changes to 00.0.When I then stand on it it gives me an incorrect reading.

SOURCE: conair scale ww36gd err reading

I have a WW36DG digital scale and most of the instructions are the same, so far as I can see. When you tap on the scale, 888.888 appears. It is just seting itself. If you step on the scale before it reads 00.0 it wil give you a Err signal. If you stepped on the scale after it read 00.0, and an Err signal appears, either your battery is very low or it is malfunctioning. it does have a 10 year warranty on it. For the person wanting to set the scale, here are the directions. Good luck.

Customizing Your
Weight Watchers® Body Fat Monitor
1. Tap center of scale platform with foot to activate digital display (display will
flash).
2. Wait for "0.0" to appear in display window.
3. You are now ready to input your personal data. Firmly press the SET button
located below the display.
Enter User Number
• P-01 will flash in display window
• Press UP or DOWN arrows to select your individual user
number (Ten user numbers available: P-01 through P-10)
• When selected user number appears in display, press SET
button to save user number
• The scale is now ready for you to enter your height
Set Height
• "Ht" (height) will flash in display window
• Press UP or DOWN arrows to scroll to your height measurement
• Press SET button to save height
• The scale is now ready for you to enter your age
Set Age
• "Age" will flash in display window
• Press UP or DOWN arrows to scroll to your age
• Press SET button to save age
• The scale is now ready for you to enter your gender
Set Gender
• The gender icons will flash in display window
• Press UP or DOWN arrows to select male or female icon
• Press SET button to save gender
• The scale is now ready for you to weigh yourself and to
determine percentage of body fat

SOURCE: weight watcher scale not calibrating weight correctly

Press the scale once with your foot. All screen options should display to initialize and then go to 0.0. Now step on the scale. It should read out your correct weight. If not, first remove and replace the battery for reset. If still not, replace the battery. If still not it's ready for return or replacement. Hope it works! Dave - CA

SOURCE: My weight watchers scale reads ron when you tap it.

I would contact customer support here is the webpage on the site.


http://www.conair.com/-cn-18.html

SOURCE: I have a Taylor body fat analyzer and scale model

From the Taylor Site http://www.taylorusa.com/faq-scales

Here are the basic ERR messages and their meanings:

• Error 0: Initialization
• Error 1: Instability (scale is on an uneven surface ex: carpet)
• Error 2: Unit may have been jarred or unit was overloaded (customer went over the maximum weight capacity)
• Error 3: Contact error (Feet were not wet for Body fat reading, feet aren’t big enough to reach sensors)
• Error 4: Body fat is out of range
• Error 5: Water is out of range

1. Remove the battery from the scale.
2. Sit the scale on a hard surface floor.
3. Step up onto the scale, stand still for about 5 seconds and step off the scale.
4. Re-install your battery.
5. Place the scale back on a hard surface floor.
6. With one foot only, place just enough weight on the scale for the display shows zero’s or dashes. Once you see zeros or dashes remove your foot.
7. Wait for the scale to turn off again.
8. Step up onto the scale for a weight.

SOURCE: Conair thinner scale model TH402 displaying incorrect weight?

Conair TH402 displayes incorrect weight