An air compressor with a long extension tube that can reach up in the cyclone chamber
If you are talking about te part where the filter goes in, i found it best to get a cup of warm water and take filter out and add water and swirl it around a little dishsoap in the water will help. if your talking about inside the actual ball that rolls. there is nothing in their you should need to worry about that is where the motor is and usually doesnt need cleaning because of all the great filter system that dyson has good luck
SOURCE: Dyson Animal .. how to get to Chyclone chambers for cleaning??
The cyclone assembly is glued and cannot be taken apart. The best way of cleaning it , is to remove the top held on with three hex screws , the bottom collecting vessel and the perforated filter. Then blast the cyclones from above with either a pressure washer or hose with a high water pressure source. Leave to completely dry , then reassemble.
SOURCE: I have a Dyson Animal
I looked in our DC07. I would try removing the top again and getting a long dowel or the opening rod, insert it down into the unit and PUSH. The opening rod opens the latch by pushing it, not pulling it. Here are some pictures of the latch. Top pic is in the unlock position. Bottom is the normal position.
I hope this helps.
SOURCE: Dyson Animal, purple ball, no suction upright
you might be missing a blockage in the hose from the brushes to the dust collector Take apart the hoses and check
SOURCE: I have a dyson animal
There is a linkage between the on/off and the beater bar switch that probably has came loose or is broken. It also could be wires shorting out.
253 views
Usually answered in minutes!
×