Konica minolta c550 error code c-3102 how to resolve

SOURCE: Konica Minolta bizhub C250

i think that your fax is not set up right, or maybe the machine is missing admin and machine e-mail address, that can cause too this problem.

SOURCE: Error code on Konica Minolta C350

There is not a C0876 listed in the service manual. Perhaps it's a C0B76 - Finishing option Punch Unit Board Malfunction.
CAUSE: The shaft on which the gear rides is deformed. The punch unit cannot be driven from front to rear.

SOLUTION: Reform the shaft toward the punch unit rail. This will allow the drive gears to mesh properly so the punch unit can be mechanically driven from front to rear.

SOURCE: Bizhub Konica Minolta - Error Code C1183

First check the alignment front and rear of the finisher, check the finisher exit guide rollers if the paper is exiting properly, open both rear and the front cover and check the lower gears attach is the up/down drive belt. that lower gear one might be broken by the pin slot.

Duane Wong

• 6826 Answers
• Posted on Jul 14, 2010

SOURCE: i have fetal error code 08H,14H &15H in

　When fatal error codes are displayed call tech support at Konica Minolta:
http://kmbs.konicaminolta.us/content/salesservicelocator/findservice/findservice.html

　
FATAL ERRORCODE:XX
An error has been detected with the item indicated "XX" in the service message.
Reboot the printer. This often clears the service message, and printer operation can resume.
If the problem persists, contact Technical Support

amir hamza

• 318 Answers
• Posted on Aug 07, 2010

SOURCE: Solution for error code c2557 konica minolta bizhub 250 machine

ADTC sensor failure