The cord gets hot

my black nd decker iron lights up but will not heat.

the contact switch for heat control not get good contact or dirty need to clean.

Bring the iron to a Hardware store, ask for a set of tools right for the type of screws (maybe Torx, Security Torx, tri-wing, bristol and others).

Once you can open the iron and access to the cord you may change the power cord. it is easy.

Power goes on & off because the power cord is broken. This failure is very common on irons.

Good luck

mcdevito75 here, You may have a problem with the heating element in your iron, Check to see if you have a Warrantee if so, return the iron to Black & Decker. In the meantime look for an appliance repair shop in your area and have the iron checked out.

Hi,
Here is a tip that will help you with that problem...

Cleaning a Steam Iron Soleplate
http://www.fixya.com/support/r5301167-cleaning_steam_iron_soleplate

heatman101

first you get the iron hot,
then you use a damp towel,
and rub firmly

change the thermal fuse inside iron that's why not getting hot. thermal fuse blown up due to overheat inside.

under the knob to press to retract the cord there is a screw,
slacken it ad try to adjust it again.

Please call Black & Decker customer service at 800-231-9786 so that we may determine your warranty status. Mon - Fri. 8:30 to 6:00 EST.

purchase it from==
http://www.powercord-manufacturers.com/
thank you for using FixYa