I have a Seiko QUP101K alarm clock,but have lost the battery. Does anyone know which battery it takes?

SOURCE: Seiko Westminster Chime Clock; Model No. QQF150G Caliber 12105

Does this help

http://www.theclockdepot.com/seiko_westminster_clock_instructions.html

SOURCE: reset timer after battery change in seiko sna285

If the stop watch hands are not in the "0" (12 o clock) Position, follow the prodedure below to set them to the 12 o Clock position

1, Pull the crown to secound position
2, Press Button "A" for 2 seconds.
3, Press Button "B" to Adjust the minute Hand to "0" Position
4, Press Button "A" for 2 secounds then press Button "B" to adjust secound hand to "0" Position
5, Press crown into normal position

From:

AmFix Jewelry & Watch Repair
203 N. LaSalle Street,
Chicago, IL 60601
Ph: 312 641 7000
Email: [email protected]
Web: www.goamfix.com

SOURCE: I am looking for PDF or online instructions for

Go to seikousa.com and email cust service. They will email you an acrobat version.

SOURCE: I have a seiko chonograph couturo alarm. 100m

Many of the Seiko Chronographs have the same setting options (mine is the lightweight "Titanium Sports").

First off, the alarm dial must show the same time as the actual main dial. If not you must adjust this first.

Pull the knob at number 4 position on the watch face out, until you feel two distinct notches/clicks (around 0.5mm travel) and the alarm will make a shrill buzzing for about 1 second.

Now turn the #4 knob to move the small alarm dial at the #6, to be the same as the actual time displayed on the main face, and press the #4 knob fully back in. This sets the alarm and the main time to the same ....er....time. You do not need to do this again, unless you adjust for daylight saving times during summer/winter.

Now you can set the alarm chime point.

Pull the #4 knob out again, but just one click. You should hear one ping from the alarm. Now press the button at #8 position. It will move the small alarm hands by 1 minute intervals, and if you keep it held in, the dial spins around quickly. This allows you to adjust the time the alarm will chime.

When you've got the alarm time and it's chime point set, leave the #4 knob at one click out.

If you wish to switch the alarm off simply press the #4 knob back in, and the alarm dial will spin around to the same time as the main dial.To re-enable the alarm pull the #4 out one click again. It's quite simple once you get the hang of it.

SOURCE: how to change settings of Seiko world time alarm & desk clock

I have the user manual for this clock for anyone who sends me his e-mail address.....
[email protected]