SOURCE: Frigidaire Electric Range error code
Hi jacksmdmat,
Your f30 problem may be a bad sensor circuit. It may have an open connection or just plain defective sensor. Check the connection between the clock and the sensor as well as disconnect and measure the resistance of the sensor - should be about 1090ohms at room temp (75F)
SOURCE: F13 flashes on my Frigidaire electric range
F-13
Control's internal memory may have
become corrupted.
1- Press Cancel key.
2- If fault returns disconnect power, wait 30 seconds and
reapply power.
3- If the problem persists upon power-up replace the display
board.
If you need further help, I’m available over the phone at https://www.6ya.com/expert/craig_3fa289bf857b1a3c
SOURCE: we have a f10 error code on our electric range
F10 is thermal runaway. The RTD is most likely bad. Open the oven door and look in the upper corners you will see a little metal rod protruding from the back of the oven, this is the RTD or resistive temperature device. A local parts store should have these.
SOURCE: my frigidaire electric range had a f1 code come
Hi,
The F1 code is a failure of the ERC (electronic range control), the only fix would be to replace the control board.
SOURCE: Frigidaire FEF336BC Electric Kitchen Range F7 10
The "F7 10" fault code implies the left front potentiometer/left front burner switch is open and will need to be replaced. Here is that part to order.
2,320 views
Usually answered in minutes!
×