I got a singer futura 350 embroidery and sewing machine. This morning when i wanted to switch it on to embroid something the machine made a beep sound and all the lights is flikkering at once. Can anybody help me please. What can I do to fix it

Most likely that guide is needed for the machine to operate correctly.

Tags have the singer futura xl 400 it making me crazy the embroidery is...

Since... xl 550 futura singer sewing


...

Am unable to locate any information regarding this error. Perhaps one of these links will be helpful:

Home SINGER Futura Support

FAQ about the Singer Futura


...

bobbin thread is too high pressure or too low pressure on teh top adjustment!

remove bobbin and turn tension screw about 1/8turn left (anticlockwise) check if still grabbing, if so - top thread turn about 1/4 turn (at embroidery ir should do automatically, but sometimes need kick...).

check if it is still grabbing on the bottom, do it grab during straight? zigzag? double zigzag? if do not - setting on the pattern need to be look at. if it tangle as well on these three - need definitely servicing...

follow manual how to adjust.

Hi,
It depends where do you want the embroidery to be.
If is on the front part of the cap there are two ways:
One is with sticky stabilize rmaking sure all the parts of the cap are laying flat on the sticky paper.
The second way is with a special cap attachment (sells for around 440) that comes also for the singer futura.

HI,
The machine has to be leveled. What I mean is that the embroidery part has to be level so the conector can send the information to the machine. Turn on the machine, open the software at the computer and try to pull the embroidery arm a little up (very carefully) if the hoop moves and the machine beeps it means that the computer is comunicating with the machine. Try to put something under the machine to level it.

Is the problem with embroidery only? If with both sewing and embroidery function and there is no error code (just 00) on the display, my wife experienced the same problem. There was an internal sensor that was bad. The sewing machine shop repaired with a new Singer part. Part was about $20, labor was $180.

Dear Magarita, The safety device is activated when thread gets entangled around the bobbin case. First check by removing the plastic see-through plate. If necessary remove the 2 scews on the metal needle plate and remove the bobbin case completely. Put it back and test by turning the handwheel. It should turn freely.

Hope this solves your problem.

Hi Vanessa,

Please give me more info in order to help you. Are you trying to use the embroidery unit? If yes, did you send a design to the machine via your computer?

There is a numbered dial which has numbers and the letter E.  Turn it to E for embroidery.  Thats is the correct tension.

Under the embroidery attachement (on the front side) is a lever to engage or disengage the "feed dog control." When embroidering, you need to move the lever to the level to disengage. The feed dog control should only be at the righe side position, or raised when you are not using the embroidery attatchment.