My husband is in the hospital and is not capable of changing his information He doesn't have any device that would allow him to do so J xxxxx / Aileen x xxxxxx

No, but if the hospital allows it, why not?

The steps below will help you fix the problem easily.
1) Open cmd(command prompt) with administrator rights
2) Type slmgr.vbs -ipk xxxxx-xxxxx-xxxxx-xxxxx-xxxxx (x should be replaced by your 25 digit product key)
3) Hit enter
4) Type slmgr.vbs -ato (This will change the product key)
5) Hit enter

How to fix Windows Activation Error 0x8007232b:
Solution 1:
Change the product key to an MAK. To do this, follow these steps:
1. Search CMD and run as an administrator.
2. At the command prompt, type the following command, and then press Enter:
slmgr -ipk xxxxx-xxxxx-xxxxx-xxxxx-xxxxx
NOTE: Placeholder xxxxx-xxxxx-xxxxx-xxxxx-xxxxx represents your MAK product key.
Once you are done with this, you should see this:
Just restart your computer and the problem should be resolved.
Check the other solutions here How to fix Windows Activation Error 0x8007232b Fixed

A Registration number is when the computer is registered.
Registered with Microsoft, or perhaps eMachines; for example.

To me an erroneous procedure, as it just gives them Personal information about you, which they DID NOT have, and DO NOT need..........

"Oh get great information about Windblows, or use eMachines (Insert any computer maker here), helpful tech information...."

UH, NOT.........
Nothing good comes from it.......

For a computer that is Not registered, it is just Activated.
The Windows program is Activated.
This requires using the Windows Product Key, which is found on the Back of the computer, or up on the side of the computer tower.

Let these X's represent letters, and numbers.
The Windows product key is 25 characters long,

XXXXX-XXXXX-XXXXX-XXXXX-XXXXX

For additional questions please post in a Comment.
Or click on Reply at end of solution, and post.

Regards,
joecoolvette

CHEVROLET DTC P1601 - Serial Comm. Problem With Device 1

The Powertrain OBD System Check prompts the technician to complete some basic checks and store the freeze frame and failure records data on the scan tool if applicable. This creates an electronic copy of the data taken when the fault occurred. The information is then stored on the scan tool for later reference.

The UART serial data circuit must be OK so the IPC can send the password XXXXX to the PCM. A DTC P1601 being set would indicate that the UART serial data circuit cannot be used to send information and causing the P1629 also.

An IPC theft deterrent DTC being set would indicate that the Passlock System is faulty and not sending a password XXXXX the PCM. Additional information can be found in Accessories and Optional Equipment / Antitheft and Alarm Systems. See Accessories and Optional Equipment\Antitheft and Alarm Systems

After any Passlock System parts have been replaced, the PCM must relearn the password XXXXX these components.

Replacement PCM's must be reprogrammed. Refer to the latest Techline information for programming procedures.

If no faults have been found at this point and no additional DTC's were set, refer to Diagnostic Aids for additional checks and information.

Hope helps (remember to rate this answer).

Hi there.
Your product key should be underneath the laptop like this >>>>>>

Its a set of five blocks of five "xxxxx-xxxxx-xxxxx-xxxxx-xxxxx"

Use this key to activate your operating system

Thanks for choosing FixYa!!

hmm do you have buy a pirate sofware,? the code need for install the program. if yes report it to microsoft
Sergio