How to install battery for model 360 tower fan

Does this look like your Remote??
eBay: 323110383235

It ain't cheap at $40 USED and this is from a "Thrift Store"... ya sure.

"Wexford 44" VFD LCD TOWER Fan Remote Control MODEL CT-408RTFV1"


Wexford 44" VFD LCD TOWER Fan Remote Control MODEL CT-408RTFV1
A

From the amazon page:

How do you open the remote control to put the battery in? I used a coin and then a screwdriver in the slot and it barely budges.
Push the little tab inwards and pull out LGRSTAR answered on June 11, 2014


Here is a blurry picture http://1.bp.blogspot.com/-90BE4qM6n68/UxH1zSWJE3I/AAAAAAAAetc/hMBITf9AVok/s1600/IMAG3342.jpg

Try WD-40

you have posted under sewing machines so may not be seen by the experts here.

Follow the power cord. If they have a fuse, it will be attached to the cord.

this happen to me one i just went in bought new fan took the good remote out and gave them back the bad one brought it all back and got my money back.good luck

I just used an air air compressor with a soft rubber tip and went at my two tower fans outside. It took maybe 10 minutes shooting air in from many different points but both fans now work as good as new. If it's been a couple of seasons like mine you'll be amazed at how much blows out.

You might have a stripped gear in the tower where it oscillates. Hope this helps!

plug in fan and use the remote the same way you would press the buttons on the tower fan. Just press ON on the remote and select MODE and SPEED as desired. If unit does not turn on, check the the batteries are fresh and installed correctly.

I have an Aloahbreeze Tower Fan. The remote control does not work,I put new batteries in and it still does not work. I am disabled and need the remote. It was a gift, as I have no income, so I cannot buy a new Tower Fa. Thank you, Sheila Pike Model No. 84001(FZ25-)