Bizhub c350 code c910 have troble - bizhub Konica Minolta Office Equipment & Supplies

SOURCE: copier malfunction

Code C0F36 is a low toner density error on the black developing unit.

Was it asking for black toner before this code appeared?

Johnny Massengill

• 345 Answers
• Posted on Nov 11, 2008

SOURCE: Bizhub C350 - Print spooler not running after power outage

I would print out a copy of the network configuation of that printer and ensure it has the proper network settings (I.E. IP address, Subnet mask and Default Gateway. I just worked on a printer that I accidently pull the plug on and it lost it's network settings and wouldn't print until I changed them back to the correct settings.

Good luck

Norman Weimar

• 7035 Answers
• Posted on Jul 25, 2009

SOURCE: KONICA MINOLTA BIZHUB C350 WITH ERROR CODE C0960

Check your bypass tray, the tray is on the right side of the machine, the tray flips out for legal and 11x17 paper sizes. Check that there is nothing jamed inside, code says that the tray can't lift. so check for anything jamed inside down there. As to reset the code open then close the front door where you put the toner. Turning the machine on and off will not reset the code. but open and closing the front door will clear about 80% of the service codes.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Instant Repair Help over the Phone

6ya.com

Save Time & Money by instantly connecting to...

SOURCE: c350 malfunction code c-0501

After replacing the fuser unit, if you got a c0501 code you must open the front door where the toner is. On the right side (hinge side) next to the black toner and drum unit there is a plastic pannel/cover. In the lower portion of that pannel there is a hole where a trouble reset switch is loacted. With a flashlight you may be able to see it. You are ment to use a thin screw driver or the like to push the button. You do this while the machein is on and desplaying the code. As soon as you press the button the copier will clear the code and start warming up. Thats it! If you are un certin of the button placement you can take out three screws from the pannel and loosen one screw from the pannel above it and and pull the pannel off the unit. You will see the board and it is the button on the (left), as there are two of them. Tho you only have access to the one thru the cover.

SOURCE: Konica Minolta Bizhub c350 error code c-0510

I have this code

C0510 Upper fusing roller abnormally low temp

how can I replace the thermistor in the fuser