My tre500 elect stapler stopped working - Tools & Hardware - Others

Question edited for clarity.
Question moved from 'Garden' to the correct category :>)

There is no parts schematic online

https://www.google.com/search?q=tre500+schematic&rlz=1C1QJDB_enCA643CA644&sxsrf=AOaemvJNnx6Zf4GQ2LNpRlkuxod2vAS43A:1637978060609&source=lnms&tbm=isch&sa=X&ved=2ahUKEwj7587jt7f0AhVaQ80KHS6OBWIQ_AUoAnoECAEQBA&biw=1920&bih=937&dpr=1

But you could use their 'Submit a Request' to ask them for a the parts schematic, or ask them to fix the 'spring that fell out of it when you were using it'.

https://support.stanleytools.com/hc/en-us/articles/360012685218-TRE500-Sharpshooter-Stapler-Instruction-Manual

..

Hi this is a link to download a MANUAL for stanley tre500, I hope it helps...
http://www.download-genius.com/download-k:tre500+manual.html?aff.id=7195

Morning Rhonda,

According to Stanley's own website, the TRE500 will only use either 1/2" or 5/8" brads.

Regards
Alex Bostitchtools co uk Bostitch Nailers Staplers Fasteners Coil Nails Staples

Please download the instruction sheet from the following link which explains how to load the brads. Make sure you have the correct size of brads mentioned at the bottom of the instruction sheet.

TRE500 Sharpshooter Stapler Instruction Manual

The stapler should have a label on the side indicating the sizes and part number. If not the sizes are 1/4" -part # TRA704 and incrementally upward to the largest 9/16" TRA709. The big box stores don't have them..I was looking online for them when I came across your question. Good luck.

Go to this link.

They will have what your looking for at your local Sears or Lowe's. If you go to www.bing.com you can type Electric Stanley Tre500 Staple Gun into the search bar and it will bring up some links for you where you can buy the product online.

here is a link to the manual

http://homeappliance.manualsonline.com/mdownloads/f2624d76-9579-4c12-a9f1-22eab6ac3388.pdf

My electric stapler has quit working. Why would it do that.

It would seem that 9/16 is a bit long to attach canvas and may even penetrate through to the working surface unless the backer board is much thicker then 9/16.

1/4 or 3/8 may be more suitable.

Good luck
Aduz