My Trojan treadmill show error on screen and doesn't wanna do anything. how can I resolve this issue

It is an issue with the safety key. Remove it and push it in firmly.

TROJAN PEGASUS 400 USER MANUAL Pdf Download

ManualsLib https://www.manualslib.com > ... > PEGASUS 400

View and Download Trojan PEGASUS 400 user manual online. PEGASUS 400 treadmill pdf manual download.

• 
  

  Trojan Pegasus Instruction Manual - Treadmill

  https://www.manualslib.com > ... > Treadmill > Pegasus
  
  View and Download Trojan Pegasus instruction manual online. ... Ensure that the safety key is installed, as the treadmill will not power on without it.

The E0 error code on a Trojan Stamina 315 treadmill typically indicates a problem with the speed sensor. To troubleshoot this issue, you can try the following steps:

1. Make sure that the treadmill is properly assembled and that all connections are secure.
2. Check the wiring for the speed sensor and ensure that it is properly connected to the control board.
3. Check the speed sensor for any damage or wear, and replace it if necessary.
4. Inspect the belt and deck for any damage or wear, and adjust or replace them as needed.
5. Make sure that the safety key is properly inserted and that the treadmill is in good working condition.
6. If the problem persists, try resetting the treadmill by unplugging it for a few minutes, then plugging it back in.
7. If none of these steps resolve the issue, it is recommended to contact the manufacturer or an authorized technician for further assistance.

Question edited for clarity and spelling 'stamima' to 'Stamina'.
help in the link

https://www.google.com/search?q=trojan+stamina+320+e2+error

..

If you wish to get some details about treadmill error codes ; visit the site linked here. Pull up older posts. http://electro-medical.blogspot.com/

Manuals Treadmills Downloads Trojan Health

I'd you wish to get some details about treadmill error messages and repair then check the following link
http://electro-medical.blogspot.com/

please test the following steps. God bless you

ERR1 indicates a speed issue. In this case, the motor speed as reported from the optic sensor differs
from the speed setting.
Analysis: Optic sensor signal issue -- Either the optic sensor signal is not right, or it is read incorrectly, or
the signal is not reaching the display.
see the diagram attached.finally reset the small switch, use small pencil erase for to click. the switch is to side the main power

To fix the error you have to put the safety key in start it it and wait for it to say E7. Now press stop and incline( up) together and hold for 20 seconds. Your treadmill will start to incline up. Take out your safety key. You just restarted your treadmill and can now put the safety key back and your problem will be fixed.

Your problem might possibly be that a magnet has fallen off. Here's an illustrated guide that should make fixing it easy: http://fixmytreadmill.blogspot.com/2010/10/how-to-fix-treadmill-e1-error.html

Good luck.

Your problem should be that a magnet has fallen off. Here's an illustrated guide that should make fixing it easy: http://fixmytreadmill.blogspot.com/2010/10/how-to-fix-treadmill-e1-error.html

Good luck.