Need part 9.036-694.0 to replace water inlet that cracked. Can not find this part for a karcher model 395 m water pressure washer

It sounds like you have cracked head.. is the unit surging/cutting in and out when you turn it on, this is a sign of a cracked head.. this is often caused by warm water entering the unit even slight warm water like leaving the inlet hose in the sun for an hour before using the cleaner

Brad

low pressure usually caused by cracked head but more commonly by dirty or broken valve (two per cylinder) remove and inspect each valve for debris or missing orings etc then replace before opening the next, a short cut sometimes is to blow compressed air through the inlet,

I have a larger gas powered karcher, just make sure the water going to your karcher is not obstructed from its path. on mine i bought a goodyear hose that can be purchased at northern tools or any hardware store. and use it just for pressure washing. good luck!

I think there are 4 bolts you have to take out, they are at the end of the pump,, but i think the intake and output are on that part,,,also if you ever cant find a karcher pump a king will fit

Plastic Pump Manifold is cracked.
Can be replace at a local Karcher Service Center, or if you are mechanically handy. Replacement Manifold Complete, is available from www.karcher.com.
If it is under 1 year old, and under warranty Karcher will replace if you have a Receipt proof of purchase.

Take a socket that is the same size as the black plastic and tap it down through the hole until it comes out. I have done several of these this way.

Depending on the model of the machine, it is most likley a cracked control head or split outlet elbow. Remove the covers and run the machine to locate the source of the leak. Ifit is the control head it will spray water from the top just behind the chemical inlet elbow.

I found that by putting the housing in the freezer for a couple of hours, i was able to tap the metal and plastic body apart and install the new inlet elbow.

Had the same problem.Those hose inlet are very delicate.
I went to Home Depot,to the Garden Section in the hoses stand,and found a flexible connector for about $ 6.00 and I used it as a replacement for the broken hose inlet.
Good Luck!