Jet 3 chair will just stop no lights flash will start short time later

SOURCE: Whirlpool ADP951 Dishwasher

Processor board sound bad. May be a loose plug ( or corroded connection on the plug ) . Unplug the dish washer from the wall plug before servicing. The open the front panel to expose the panel control board. Unplug the panel plugs and inspect them to assure no corrotion is apparent. If you see corrotion, use a pencil erracer to clean all contact points on the board and clean the plug the best possible. Plug the dishwasher plug back in the wall and check the unit for proper operation. If the operation is not correct, replace the circuit board. I hope this helps
Ed
NC Electronic
Mills, Wyoming

SOURCE: The charge lights blink and the chair won,t go.

Just had this problem with my Guardian Aspire. They had to replace the electronic box with the joy stick. BIG BUCKS!

SOURCE: lights just flash on controller and wont move jet 3 wheel chair

Do they flash in series? Like ten flashes then a pause then ten flashes?

SOURCE: lights on hand control flash off and on and chair will not operat

There is a series of diagnostic flash codes associated with the controller. The diagnosis depends on which color and how many lights are flashing. If you post the combination, I can help you. Or you can download the Basic Operation Instructions of the Pilot Controller from the Pride website. The codes are listed on page two on the troubleshooting instructions.

SOURCE: pride mobility Jet 3 Ultra Power Chair 7 flashing

a 7 Flashe code. There is a joystick fault. Make sure the joystick is in the center position and then power off and on again. Check all your couplings. make sure when turning on the unit you only mash the power button for 1 sec. 2-3 sec will put the unit in "Lock out mode".
This ierror will also be present if the joystick is off center when powered up. If you experience these symptoms, you must first make sure there is no physical damage to the joystick preventing it from returning to the center position. Then turn the power off and back on again (making sure the joystick is not depressed in any direction. If the joystick repeats this error, the controler much be replaced. [email protected]