What does a C76 or C77 error code mean on a Dacor wall oven?

SOURCE: Dacor Wall Oven Epicure EO130

I would call the store you bought it from or dacor as it is under factory warranty...

SOURCE: dacor convection oven cps127/130 failure code f1

i found my circuit/schematic tucked inside the back panel in a envelope, you have to remove the oven from the wall to gat to it and start un screwing the panels, i think it was on the top.

SOURCE: dacor cps130 wall oven f1 error

According to the manual, this is an element relay circuit failure. Call the tech.

Vitaliy Gins

• 78 Answers
• Posted on Dec 18, 2008

SOURCE: dacor single oven flashes an F2 error code and won't stop beeping!!!

This is from manufacture service manual:

-F2- Alarm Heating Mode High Temperature
Is activated when the ERC senses a runaway heat condition or when the temperature exceeds
“runaway limits”. The ERC will beep until the cancel or another function is selected. If the alarm
repeats the F2 alarm check the oven sensor and wiring after fi rst checking for a stuck relay. If alarm
goes away verify the oven will complete a clean cycle without any type of failure.
Another words the problem with oven sensor or relay board.

I’m happy to help further over the phone at https://www.6ya.com/expert/vitaliy_f406165329c75ede

Instant Repair Help over the Phone

6ya.com

Save Time & Money by instantly connecting to...

SOURCE: Dacor error codes

HI. the F-1 code is a System Watchdog Circuit failure code.

Press "Cancel", if beeping continues after 30 seconds, replace the main control board (also called clock or ERC).

Concerning the F-5 code. This is an oven temp sensor failure code. have it replaced asap. ((Check the wiring leading to and from the control and sensor for cracks and fouled structure. if the wiring is bad, replace the harness as well)),