Question about Ryobi Drills
Cost more to repair than the tool cost. buy a new one.ifyour battery is any godd they will work in new one.
Posted on Mar 11, 2018
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
how new is the tool. Give me the serial number and I will come up with a solution, also what is the switch number you bought. Let me know.
Posted on Jan 02, 2010
Very common fault in power tools. You will have to see if the manufacturer can supply a new switch /speed control assembly.
Posted on Jun 05, 2010
SOURCE: gr450 grinder variable speed has
i woulkd take switch off and rewire it. It is not a very difficult thing to do. As you take it apart just pay atention to where the speed control wires are running from and go from there. If it still dosent work than the switch is burnt out
Posted on Apr 17, 2011
This problem sounds like failure of the Variable Speed Potentiometer component. Here is the most helpful Fixya article so far: http://www.fixya.com/support/t6032529-need_replace_speed_control
I have the same problem right now and don't want to pay ridiculously high prices for a small electronic component.
So far, this is as far as I've gotten in researching replacement parts:Vitamix Part #015955
Partstown sells #15955 for $23.39 on their website but I found out they charge $15 for shipping -- for a one-ounce piece of electronics. I won't pay to be ripped off on shipping so I won't buy one from Partstown until I've exhausted less-expensive suppliers. Here is the product at Partstown: http://www.partstown.com/vita_mix/vm15955
Another Fixya contributor, Robert Sadler, said he was going to try a generic potentiometer from Mouser.com. His descriptions are kind of vague for me. I'm not an electronics expert so I'm not very confident I can interperet his description:
"If you are comfortable with soldering, you can get a replacement part at Mouser.com. The pot is a 5k "slimline" made by Bourns, however looking inside the cover it looks like most pots would fit. I ordered one for a bit over $5 and will update when I get it with how it worked. You would just have to solder the existing wires to it." -Robert Sadler
I have no problem soldering the existing wires onto a new component but I don't really know what would be an appropriate potentiometer to buy as a replacement from an electronics supplier. In addition, Mouser's website seems to sell potentiometers only in bulk quantities of 5, 6, 12, or 45 items at a time. I just want one.
If anyone knows how to interpret Robert Sadler's comments, or has actually done this repair, please post below. I'm sure quite a few people would benefit from a high-quality repair at a low component cost.
Posted on Nov 19, 2011
Tips for a great answer:
May 29, 2012 | Office Equipment & Supplies
Aug 29, 2011 | Ryobi 18v Cordless Drill - P206 18 Volt V
Apr 17, 2011 | Delta GR450 ShopMaster 8'' Variable Speed...
Mar 24, 2011 | Ryobi Drills
Jun 03, 2010 | Drills
Mar 23, 2010 | Ryobi 18v Variable Speed Impact Driver...
Apr 04, 2009 | Ryobi 18v Variable Speed Right Angle Drill...
116 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: