Lanier lw310 wide format printer/copier has a cable with a 26 pin MDR connector. How can I connect this to my ASUS computer?

SOURCE: printer busy/or error

Sounds like your machine is using DHCP, not a static IP address?

Print your network settings from the Printer, then try to Ping from a computer on the network.

Check the Network setting of the machine, make sure it is set to a fixed (static) IP Address.

If this is the problem, you can go into your PC printers port and change the port to the reassigned IP Address of the machine.

If you reinstall the drivers then you will have this installed twice, one will work one will not, so delete it from the printers folder before you reinstall before you reinstall

SOURCE: need pin out info for aqua vu 4 pin connector

I figured it out:

Here goes: There are 4 wires inside the Aqua Vu cable that runs to the underwater part of the cam.

Red = Hot or 12 volt power from battery postive (red) terminal

Black = Ground - ground to battery negative terminal

White= Video input (or center of video coax)

Green= Infrared lighting control, if you ground the green wire against the black/ground, you will see

that it switches ON the infrared or "Christmas" lights. Simply put a switch on the green wire after you ground it, so you can switch your IR's on and off.

SOURCE: Lanier copier won't scan to computer

IF you're scanning to folder, check your security settings in file sharing. Try allowing all permissions to each listed and apply.
If you there is a computer that you know definately works already, have a look at their settings in security tab of file sharing - and change permissions to allow full control (for now). See if your scanning works.

SOURCE: Looking for identification of wiring pin-outs for

Take your time; when it comes to that you must take your time Look for matching connectors

SOURCE: ASUS P5KPL-AM CPU fan connection.

You should still be able to connect the 3 pin connector of the fan to the 4 pin connector on the mobo, the keying tab is offset so that you cannot connect it to the wrong pins.
If you still don't want, or can't connect it there, simply go on the Bios (press delete after you turn on your computer) and you will find an option to monitor CPU fan speed.
If you need any more help, let me know

Alex
www.CAS411.com