After running a " normal" cycle clothes are still soaked and when i run a drain and spin cycle. Instead of spinning out it continues to add water and thus still leaving clothes soaking wet
SOURCE: Washer won't drain during the spin cycle
you would need to get to the pump,,,its probably a sock of some piece of clothing stuck in the pump. its under the washer.drano wont help with this sorry
SOURCE: Washer drains then spins then fills again and drains but no spin
Try this, unplug washer for two minutes, plug back in, open and close lid seven times slowly, this will reset the computer and the electronic motor. Also on water level switch, make sure hose from switch to tub is not plugged, blow it out, gets clogged with soap.
SOURCE: Washer works on every setting but does not spin on spin cycle
IF ITS A TOP LOADER ITS POSSABLE YOU HAVE A BAD CLUTCH IT A FRONT LOADER YOU MAYBE USING TOO MUCH SOAP
If you need further help, I’m available over the phone at https://www.6ya.com/expert/dude_653d05454b389bba
SOURCE: During the spin cycle water pours continuously like fill cycle
This problem is commonly attributed to either a water inlet valve leaking by, or a pressure switch malfunction. The following link explains how to diagnose the problem:
http://www.fixya.com/support/r3753517-whirlpool_top_load_washer_fills_when_not
I've included parts sources (if required) and how to repair each problem. If you have any questions, please post back and let me know. I hope this information is helpful to you.
9,171 views
Usually answered in minutes!
Jim, we’re sorry to hear of the concerns you're having with your Maytag® Washer. We'd like to follow up with you regarding your concerns. Please email us at [email protected] with your name, phone number, address, the website you were contacted on (Fixya), the model/serial number and date of purchase so we may do so. Please include a brief description of your concerns in your email. Thank you Maytag® Social Care
I also am having this same problem, may I ask what the fix was?
Me too! It's Drain and spin should be no water involoved
×