Re-calibrate healthrider h120t??? My unit only beeps when the key is placed. NO buttons work only beeps when you push them and if you don't.

Check for loose bolts: Over time, screws or bolts can become loose and cause the magnets to shift, leading to changes in resistance and affecting the bike's efficiency. Consider fastening bolts and screws in their respective places to prevent them from causing such shifting problems .

Inspect the console: If the electric console is malfunctioning, it can lead to error code issues that display on the monitor. Such problems need immediate repair before they cause the entire machine to stop functioning. You can either repair the existing console or replace it with a new one. It's best to leave this project to a specialist who can deal with it effectively .

Contact customer support: If none of these steps work, consider contacting HealthRider customer support for further assistance.

Before inserting key hold down stop key then insert key then turn off demo mode

you have a botton that is sticking

All icon models are the same. The easiest way to incline calibration is to start the treadmill, push the incline up button and then after you release the button, remove the safety key. Replace the safety key and the treadmill should calibrate.
If that doesn't work, press the stop and speed up buttons and hold, then place the safety key in place. This will bring you to the speed/incline calibration. Press stop again. now press incline up. This will run the incline calibration.
You may need to remove the hood and manually with a drill lower the motor. Using a slot screwdriver bit, lower the motor a bout 50 turns and then try the procedure above again if necessary.

hi Geoff,

if it is contain belts please check.and try to move running belt it must run freely.sometimes it must stuck because of long idle time.
in electronic circuit the large smoothing capacitors can be damage because of long idling time too.

let us know the status,
regards.
nuwan

I have a healthrider h120t when i put the magnet it beeps once and everything all the displays stay on zero but nothing moves

The serial number decal should be in front bottom left hand side on the frame opposite the power cord. I would not worry too much about the serial number that is used for tracking their units. It sounds like the motor control board may have failed, but they may have you do a calibration to see if the board has actually failed.

Press the Stop and the Speed Up keys down while inserting the safety key and try to get this unit in calibration mode if you cannot then, the upper console will have to be replace.

If you have a unit where the start button is not working most of these units will make some sort of beeping sound if you depress start button and no sound it maybe the key pad itself is causing this problem. Depending on manufacturer you can purchase the keypad/overlay and some will want you to purchase the entire display.

Unfortunately, you need to replace the entire console. HealthRider's consoles are notorious for this behavior. The company that manufactures them only sells the console as a whole unit so you can get individual parts. Depending on the age of the machine you'll be looking at between $300-$800.