I need a replacement. I can't locate one. - Goodman GMS90703BXA Heater

If you go to this web site it will have pictures of the location and how to replace it
www.autocross.com/Replacing_a_freeze_plug/ccr200704011/1

Yes the airbag module must must always be replaced. Its most likely located under the mid console. Not sure about location

www.car-part.com

If you buy one from the dealership you will know what it looks like !
Replacing it , , , it can be located in a few locations but it is usually on the bulkhead under the hood.

just replace it,it's located next to the oil filter.











TIM...........

If you are talking about O2 sensor ?? The sensor is locater either in the exhaust manifold or the exhaust pipe. It's not hard to replace in either location. Hope this will help you.

If you can't find the fuse how do you know it needs to be replaced?
The fuse will probably be located at the beginning of the circuit, so somewhere near the plug.

the switch located inside the steering collum also as
I don't know what year your car is but if it is 1990 or
above it is air bag equiped this means the bag has to
be removed to pull the wheel,
If you have no experiance with air bags please consult somone who has it can be dangerous.
if you have any more ? gimme a buzz good luck

Im looking for the same part location on a 2002 chevy blazer. It might be under the distributer cap.

The brushes are located inside the motor. Remove rear panel of washer, remove drive belt, from motor and drum, unplug the motor, undo screws that secure motor, and remove motor.
At the opposite end to the motor pulley, you will find the brushes located, undo 2 screws that secure the brushes, remove and replace brushes.
I would also check the pump filter, which should be located behind a removable panel at bottom of washer, unscrew anti-clockwise, remove and clean.
Please rate my fixya solution.
Thanks.